Main Function:
1. Switch
Cable control is good at used in public toilet. It is used about 20-30 times per day. It is able to stand by for 3 months.
2. Delay protection
It has 8 seconds of delay between every pushing of the button to avoid useless waste.
3. Seat
The width of the seat is 60mm, with comfortable design according to human body engineering.
a. Led instruction for switch on or off.
b. When the toilet seat is working, the led is always on.
c. When the battery is low, the led blinks to remind battery charging. Otherwise, the battery will be damaged by long time working in low battery situaton.
4. Switch
Available for 300000 times of working.
5. Power supply
a. Rechargeable storage battery 6V/4.5A.
b. A/C power, as wide as (100V240V, made by order)
6. Charging mode, (two modes)
a. Charged by adaptor directly when the seat is working. There is nothing to do with the normal working.
b. Disassemble the battery from the toilet seat. Charge the battery in somewhere else. Re-assemble the battery to the toilet seat. Then use the toilet seat. (Suggestion: If you have a lot of toilet seat, use spare battery for recharging, in order to avoid stop working . )
7. Charge
Suggest to charge every 3 months, so that the battery is able to work longer.
8. Safety and energy save:
It is not dangerous to people, since the toilet seat works with weak power.
-
Installation of sanitary toilet seat:
1. Open the back cover
2. Install the battery
3. Connect the wire
4. Open the cover of the cabinet which is for clean sleeve
5. Find out the metal spanner
6. Press the spanner
7. Take out the mounting plate
8. Put the mounting plate to the closestool
9. Put the screw and adjust the position
10. Screw down, but not tighten it.
11. Push the toilet seat along with the mounting plate.
12. Well position it. Then tighten the screw. The installation is finished.
13. Stick the switch. The sanitary toilet seat is ready to work.
-
Charging mode:
1Charge while battery is in toilet seat
2Connect the battery directly and charge.
-