Specifications

The strengthening wire machine works range

Wire straightening range: wire 0.8-14mm  one-time modulation cut off.

Straight wire machine for straightening and cutting 14 mm in diameter reinforced cut-off length can be customized according to customer requirements. Adjustable straight cut stainless steel wire, aluminum wire, cold wire drawing, including plastic-coated steel wire, wound together, the error is small, good performance.

  Straight wire machine

Strengthening & Straight wire Machine structure

straight wire machine by adjusting straight, motor, pull line agencies, the cutting mechanism, reinforced fixed-length frames, racks and drive unit.

Edit this paragraph

Straight wire principle of operation and fault repair

The operating principle of the straight wire machine

Operating principle: motor by belt drive growth, so tune straight high-speed rotation, reinforced through the tune straight straightening by straightening mode clear the scale of the reinforcing steel; motor through another gear belt drive and gear reducer box, on the one hand, to drive two transport platen roller forward movement of the traction bars, on the other hand driven by the crank wheel, so that the hammer up and down movement. Reinforcing bars hammer hammering on the knife, steel cutting, cutting reinforced fall into the rack until the predetermined length, due to the action of the spring, knife sets and returns to its original position to complete a cycle. 1. Performance of the structure: Straightening institutions - by straightening rolls, straightening briquetting, and both ends of the bearing housing, completed the survey of the wire straight. Its power through V-belt driven motor mounted in the lower part of the rack, straightening shaft rotating at high speed.

  Straight wire machine

Feeding mechanism - pressure roller section consists of two synchronous operation of the pressure roller chain drive through V-belt drives a pair of gear pair, coaxial pair of press wheels along with synchronous operation. Work, metal wire through the trough of the cylindrical pressure roller running forward in the role of friction, adjust the pressure roller spring can change the wire feed speed. Its maximum value is equal to the pressure roller cylindrical line speed. Should be done in accordance with the processing wire diameter and rigidity appropriate to adjust the pressure to obtain the best alignment effect and production efficiency.

Cutting mechanism - cut off the body by an eccentric mechanism with straight end of the Silk Road turret together to complete the cut. Eccentric mechanism by the spindle, the slider, eccentric, rocker arm, and punch its power by cutting off the motor through V-belt drive to rotate the spindle, the role of the eccentric mechanism up and down reciprocating punch. Operation, when the wire straight wire channel trunking to fixed-length metal wire rapidly in the frictional force of the pressure wheel set straight wire slot to move forward, the top of the head punch briquetting rear boss working stroke to move to the punch by punch briquetting impact heads, and Cutting metal wire. Meanwhile, the punch block downlink, the depressed groove below twist closures iron, so that the seal mast rotation around the guide rod, disengaging the cutting wire trunking, automatically fall under gravity line bucket, red head row insert also come up under the action of the torsion spring, sealing the mast to re-seal the duct. The straight wire slot after the disappearance of the wire thrust under the action of the tension spring to restore the initial state into the next cycle.

  Straight wire machine

Off the wire institutions - the Order of the rack by the cyclone, gauge rod, mandrel base, wire coil around the mandrel rotation, put the disk-shaped wire feed mechanism is driven by the cyclone continuous, automatic material.