Product Details

oil-water centrifuge/disc type oil water separator

( Keywords: fuel oil water separator , oil water separator , hydraulic oil water separator )

Introduction:

DHZ series disc type separator is an automatic slag discharged oil refinery equipment. It has the following

advantages :high rotary speed, rotate stable, all sealed outlet ans inlet system , low noise, high separation

efficience etc.

This machine is widely used for animal /vegetable oil & fats hydration degum, alkali refining deodorization

and washing process it , mainly has automatic ring valve slag discharge and artificial slag discharge , it can

also be used for degumming, getting ride of nigre and washing during vegetable oil refining.

Main technical parameter:

Model	Handing capacity(l/h)	Inlet pressure(mpa)	Outlet pressure(mpa)	Power(kw)	Weight(kg)	Dimension(mm)
DHZ550E	6000-15000	0.05	0.1-0.3	22	2600	185015502050
DHZ550A	5000-10000	0.05	0.1-0.3	18.5	2600	185015502050
DHZ470	2500-7000	0.05	0.1-0.3	15	1700	180012001800
DHZ400	2000-4000	0.05	0.1-0.25	15	1500	180012001800
DHZ360	1200-2500	0.05	0.1-0.25	7.5	650	150011501500
DRZ550	1800-6000	0.05	0.1-0.3	22	2200	162013002200
DRZ400E	4000-7500	0.05	0.1-0.35	7.5	850	13009001500
DRZ400A	2000-6000	0.05	0.1-0.35	7.5	800	13009001450
DR(S)Z360	1200-2500	0.4-0.55	0.2-0.4	5.5	600	1250x1050x1500

Details pictures

Detailed packing:

Test separator and installation:

1.Check	before starting the spindle and the drum is connected preload, the upper end of a main shaft connecting joint and buffer rubber pad position is correct, whether the drum bottom shaft alignment marks the preload, the liquid inletbearing fasteners, the connection is firm and reliable, appropriate tensioner tightness, power supply connection and zero connection protection and reliable, liquid disc pressing cap is pressed liquid disc, drum rotation direction is correct;
2.The boot	starting power to observe any abnormal situation, the machine does not completely reach the normal speed, can not leave the operation power, nor feed;
3.Feeding	when the machine is completely reaches the normal speed of charging, charging is slow, and the pressure should be less than 0.1Mpa, the discharge port discharge after adjustment to the normal feeding quantity;
4.Stop	power off, wait for about 12 minutes, the machine energy completely stopped, in the machine is not completely stopped not any parts operating machine;
5.Removing	determine the machine stops will be liquid disc pressure cap loose unload liquid dish, will drum out from the body, to work on the shelves with a special spanner will bottom shaft opened, three wing drum out, clear the drum solid phase, the operator should do the protective measures, must be completely remove the drum solid;
6.Installation	drum after cleaning, the three wings of the mark in the drum, the bottom shaft installation. Should be installed in the threaded put some lubricant, check the seal is intact, the bottom shaft seat and the drum is marked, the bottom shaft and drum pre-tightening by pretightening force appropriate. If Mark misaligned, replaceable bottom shaft seal to adjust and correct, the drum into the machine, hydraulic disc connected into good spindle, pressing liquid dish.