Specifications

food grade flexitank
1,5layer flexitank:4PE+1PP
2,14-24KL,3'valve
3,product liability insurance

 

Qingdao LET Flexitank Co.,Ltd is a professional manufacturer of Flexitanks.

 

 

Electrical Heating pad for Flexitank

 

1.150x5.500m(general) 

2X1200mmX5500mm specialized for 20’ container

 

 

NOTICE: 

 

1. Output control temperature: 50°C, 55°C, 60 °C

 

2. Output protection temperature: 80°C

 

3. No heating during bulk liquid transporting.

 

 

Steam Heating pad for Flexitank

 

Material: EPDM+ caoutchouc
Working pressure: < 0.2 Mpa
Temperature range: < 220°C
Heat source: Steam
Layout dimension: 5.7 m(length) X 2.3 m(width)

Weight: 30kg 

  

Flexitank Type 

Top load&Top discharge(TT) 

Bottom load&Bottom discharge(BB) 

Top Load&Bottom discharge(TB) 

 

Fleixtank Composition 

3"butterfly valve

4 layer PE film

1 layer PP woven fabric 

 

Flexitank Accessories 

1. Steel bar---2450*277*65mm 5PCS/set

2. Bulkhead---2330*1680*20mm 1PC/set

3. Corrugated paper---1400*300 (diameter) 1roll/set 

 

4. Heating pad---avoid solidifying and keep flowing (optional) 

5. Air vent---release air (optional)

  

Flexitank Advantages

1. Low costs--saving storage, freight, cleaning and labor cost;

2. Large capacity--contain 24,000 liters liquid at most, 35%more than drums or bottles;

3. Convenient--Easy to operate and transport;

4. Environment friendly---food-grade and degradable.

  

Pics for your reference 

 electrical heating pad 

 

Steam heating pad

flexitank with and without bulk liquids

 

Flexitank Installation Procedure

Installation procedure	Pictures
1, Choose a better container, check strictly  and clean the inner flints.
2, Lay the corrugated paper in three sides and  the bottom of the container to avoid bareness.
3, Take out of the flexitank and paper pipes  from the packaging box.
4, Fix the steel bar using the paper pipes.
5, Install and tie the bulkhead& steel bar  together with a fixed rope.
6, Pave the flexitank and secure it by suspending  the four corners while opening the valve cap.
7, Fix the valve cap properly.
8, Close the left door and make sure  the foam strip doesn’t exceed.
9, Connect the valve with the pipe and set them, open the valve to charge the liquid.
10, When the loading is finished, close the valve first and then disconnect the pipe and screw the valve cap on.

 

 

 

 

 

 

 

 

 

 

 

 

Talk with me!

 

Do not hesitate!