Specifications

tattoo machine

I. Machine structure

The Nd:YAG Laser Tattoo Removal System is made up of light route system, power supply system, computer controlling system, cooling system, etc. The light route system is installed into the hand piece, but power supply, controlling and cooling system are installed into the machine box of power supply.

Main technical parameters:

Laser model:Q-switched Nd:YAG Laser

Laser wavelength:1064/532 nm            

Pulse energy:1000mj

Pulse width:3.5ns

Repetition frequency:1, 2, 3,4,5,6 Hz

Cooling method:inner circulation water cooling

Power supply:AC110V± 10%, 50~60Hz; 230V±10%, 50~60Hz

Main physical parameters:

Dimensions:370×275×245mm3

Total weight:18kg

Each part’s name and function:

1. Emergency switch:When accident happened suddenly, press the red knob swiftly, then the machine is out of power. Turn the button in the arrow direction to spring it up and power resumes again.

2. Key switch:This is the main power supply switch. The screen displays a long horizontal line. Press the “down” button to shut down the signaling voice.

3. Simm (simmer):Pressing the knob makes system enter into the standby state.

4. Freq (frequency adjusting ) key:Set repeated frequency 1~6Hz.

5. Power (power adjusting) key

Feature: 
1. The latest hi-tech of laser explosion in twinkling.
2. Don’t break the hair follicle, or hurt the normal skin, or produce the scar formation.
3. Little sense of pain, anesthesia is unnecessary.
4. Short curing time and easy operation.
5. The high quality controlled solid-state laser complying with international standard of production.
6. Computerized with big LCD and show in double languages,English and Chinese. 

II.Working condition of tattoo machine

Working Principle:

Laser emitted by the system has a strong penetration ability which allows it to reach 

the deep layer of dermis. The pigment particles absorb the light energy and explode 

sharply, burst into the tiny pieces, thus diminish the color density and get rid of it.

So the appliance can effectively do away with mutant pigmentations and vascular tissue

based on undamaged ambient tissue. This is called ‘Selective heat absorption’ principle

in medical field.

Normal working condition:

1. Temperature:5°C-30°C

2. Relative humidity:≤70%

3. Pressure:860-1060hPa

4. Power supply:AC110V± 10%, 50~60Hz; 230V±10%, 50~60Hz

Working mode:interval and continuous working mode. Best to pause for 5 minutes after each continuous outputting of 5000 pulses.

Cooling:Circulatory water cooling with distilled water

 III.Power supply

power supply:AC AC110V± 10%, 50~60Hz; 230V±10%, 50~60Hz

Connection:

1. Safety fuse socket: The safety fuse is installed into the power supply socket, using safety fuse(6A/ ¢5 ×20) which is used for over loading protection.

2. Power input socket: The machine should be connected to a power supply using a power cord.

 IV.Installation

a) The Nd:Yag Laser System should be installed into operating room or therapy room fulfilling the following requirements:

Temperature: 5°C-30°C,

Humidity:   ≤70%

b) Power supply is installed per the above requirements. Please have qualified electrician to perform checking and installation.

c) Installing navigated spin plugs:Plug navigated spin plugs into the INTERLOCK at the back of machine trunk. Machine will stop outputting laser after pulling out the INTERLOCK.

d) Installing pedal foot switch: Plug the pedal foot switch into the F00TS at the back of machine and then screw it on tightly.

e) Screwing off the stopper on the water tank, then screwing it on tightly after adding distilled water fully.