mineral therapy heat TDP lamp

Heat lamp operation instructions

It is a viable alternative therapy lamp in treating chronic inflammation, tissue degeneration and cell atrophy
caused by tendonitis.
Also, it can help healing up wounds after operation .

1.Notice

a.Join the power cord well to ensure the quipment the safe use.Power take off after use.Avoid strong vibration,proteeted against moisture,pay attention to proteet the TDP plate.

b.Radiation should not be too close,otherwaise,proue to skin burns(red or blisters) or easy to burn by touch radiation head accidentally,But if the distance is too far,will also affect the officacy.

2.Main tcchnical index

Main spectral range:2-25

power density:32mw/cra

power Gousumption:<250w(radiation head)

power voltage:50hz,220v

working conditions:ambient temperature0-40c,relative humidity<80%.

3.This device has been tested and examined strictly before leaving the factory.In case any fault occurs during its operation,please send the device for repairs to our companys distributors or sprcial repair shops in different places.Non-professional shall not disassemblethe device.

4.How to use?

a.Connect with power:Insert the plug into the socket(the voltage should be consistent with TDP voltage)open power switch,preheating 5-10minutes before treatment radiation.

b.Radiation distance:30-40cm from radiation head to treatment location.Keep the temperature in 40c.

c.Radiation time:3 days between each treatment.If the illness needs,can be continuous use for a long time

5.Our service