2013 Importer RF machine beauty equipment hair removal 2013 epileds chip

Specifications

The radiofrequency (RF) energy delivery components of the Thermage CPT
System and Accessories are indicated for use in:
• Dermatologic and general surgical procedures for electrocoagulation and
hemostasis,
• Non-invasive treatment of periorbital wrinkles and rhytids including upper
and lower eyelids,
• Non-invasive treatment of wrinkles and rhytids.
The simultaneous application of radiofrequency energy and skin vibration by the
Thermage CPT System and Accessories are indicated for use in:
• Dermatologic and general surgical procedures for electrocoagulation and
hemostasis,
• Non-invasive treatment of periorbital wrinkles and rhytids,
• Non-invasive treatment of wrinkles and rhytids,
• Temporary improvement in the appearance of cellulite,
• Relief of minor muscle aches and pains,
The Thermage CPT system must be operated only by trained and accredited
users.
3. Contraindications
The Thermage CPT System is contraindicated for patients with cardiac
pacemakers or other active implants. A possible hazard exists because
interference with the action of the pacemaker or implant may occur or the
pacemaker or implant may be damaged. In case of doubt, approved, qualified
advice should be obtained.
4. Warnings and Precautions
The safe and effective use of RF energy is highly dependent upon factors
under the control of the operator. It is important that all warnings, precautions,
and the supplied operating instructions be read, understood, and followed before
and during use.
4.1 Warnings
4.1.1 The user must be aware that failure of the System could result in an
unintended increase in output power.
4.1.2 Remove all of the anesthetic material and/or other substances (cosmetics,
lotions, etc.) from the surface of the skin at the treatment site. During the
treatment process there must be no material, other than Thermage
Coupling Fluid between the surface of the Treatment Tip and the patient’s

Power Output Restrictions
The maximum output power is 400 W. The System will operate over the limited
impedance range of 75 Ω to 400 Ω. Output power may be limited by the
current/impedance limits.
Fuses
100-240V: 10 A/250V, T-lag, 5x20 mm

Settings
• Treatment Level: up to 19 Levels per Treatment Tip
• Vibration Level: 3 levels: Low, Medium, High
 Measurement Accuracy1
• Power: ± 20% of reading
• Output Current ± 20% of reading
1For impedances in the range 75Ω to 400Ω
 Enclosure Material
System: Aluminum

 Mechanical Specifications—System
• Size: 49.5 cm (W) x 43 cm (L) x 125.7 cm (H)
19.5” (W) x 17” (L) x 49.5” (H)
• Weight: 38 kg (84 lb) maximum