Basic specification

Laser mode

Low-valance mode

Wavelength

10.6μm, far-infrared laser

Pulsed radiofrequency

0.530 W

Control 

Touching switch, microprocessor-controlled

Display

LCD display

Lcd

1.Max power : 120W

2.Pulse width: 0.05-1s 

Pulse

1. Average power: 40W

2. Pulse frequency:33.3 Hz

Working mode:

Continuous, single pulse, 

repeat pulse and super plulse

Scan Graphics

Square, rectangle, round or customized graphics

Dot quantity

400 dots at most

Working state

Hyper-pulsed mode

Scan mode

Sequence scan or Random scan

Pulse energy

10mj to 130mj is optional for each dot.

CO2 laser system

The CO2 laser with a specific wavelength of 10.6 nm can be absorbed by human body tissue (no matter what color the skin is) by nearly 100%. Through laser emitter, the micropulsed laser beam shoots on the target skin in nanometer level to achieve a controllable precise treatment .The dimension of shooting area only can be measured in nanometer, which is precise enough for operators to control and adjust the treated depth andlayer according to the clinical diagnosis.

The energy of CO2 laser is even and steady. Its focused energy aims only at target tissue without any injury to surroundings. It is the heat and electromagnetic effect of the laser that people use to conduct non-blood or less-blood cutting, cauterizing, gasification and accurate microsurgery so as to avoid skin burnt. During the treatment, biochemical reactions of optical-thermal accelerate collagen reproduction and skin recovery,after exfoliation of the tiny scar; fresh and smooth skin can be regenerated. The device outputs invisible laser. In order to operate with more ease, red semiconductor laser has been added to indicate.

Technical specification

Technology of Ultrapulse
Mainly let the original average output of the laser energy concentrated in a very short period of time then output, due to the high pulse power, short time, and more round spot, the pressure on the surface from laser heat transfer effects is low (small heat-affected zone).

Laser apparatus

Sealed off laser device stimulated by direct current

Condenser focus

f=100mm

Beam divergence angle

0.3 mrad

Spot size

Min 0.2mm at the focus

Radiation time

1 ms

Interval time

1 ms

Aiming beam

Less than 2mW, 635nm red semiconductor laser

Cooling system

Closed loop circulating water

Environment temperature

5-400C

Relative humidity

<80%

Temperature in transit

-40-500C

Humidity in transit

<85%

Beam transport device

Articulated arm with 7-joint and balance weight

Atomospheric pressure

86.0kkpa-106.0kpa

Warning up time

5 min

Electromagnetic requirement

No electromagnetic 

Field interference

N. weight (kg)

55kg

Power supply

230V/110V