Beauty salon equipment

Bi-polar radio frequency beauty salon equipment,Beauty salon equipment,ipl hair removal machine

1.Brief introduction

E-light applies three core technology,IPL,RF and epidermis cooling ,it combines the advantage of IPL and RF,in one hand ,the skin absorbs IPL energy selectively ,and the skin also absrbs RF energy ,on the other hand ,the RF-surface-touch cooling technology removing the discomfort and complications by high heat of IPL ,therefore ,the effect and safety of E-light makes a breakthrough.

2.Principle

Applying the technique of IPL and Bi-polar Radio frequency ,the equipment acts on the entire skin corium and connective tissue,stimulates the collagens of different depth to realign and grow ,then gets treatment effect ,bio-polar RF release energy at the same time ,with the selective absorption for the skin to light energy ,various pathological tissues of corius and epidemis creates photothermolysis effect ,since light energy is fatr below conventional IPL.the pigment tissue and vascular pathological tissue of the corium and epidermis would absorb more energy without injuring the epidemis,and then remove these pathological tissues better and get the effect.

3.Application :

1.Hair removal

2.Skin rejuvenation ,wrinkle removal ,fact lifting

3.Removing freckle,age spots ,sun spots ,chloasma,pigmentation troubles ,etc

4.Vascular removal

5.Acne treatment

4.Operation interface:

Treatment mode:3groups of different parameters setting

Pulsel:working time of the first pulse

Pluses:sub pulse width:irradiating time of other light except the first pulse .

Delay 1:1st pulse delay:delay time of the first pulse irradiating

Pulse amount adjusting :pulse amount of each irradiating

RF working time :working time of RF

Repeat frequency:interval between two spots

Total counter :accumulated spot times of the xenon lamp

Status display:

Back:return to the previous interface

IPL energy adjusting :increase or decrease the IPL output energy

RF energy adjusting :increase or decrease the RF output energy

Cooling adjusting :adjusting the cooling level

RF energy adjusting :increase or decrease the RF output energy

Cooling adjusting :adjusting the cooling level

Pasue/continue:"continue",standby stautus,parameters could be set in this stauts,lamp is on ,but could not make shots.

Start/pause:click"start",zimmer the handle and the capacitor charge automatically ,system will enter the treatment status when charge is ready ,click"stop",escape from treatment statuts.

5.Safety Notice

Safety of E-light

The equipemnt takes maximum consideration of the safety of both opperator and operatee in the designing ,the following are some safe measures of it .

* Circuit self-checking after machine starting .

*Using filter/light guide crystal ,strong pulse light comes out only from the front side of the handpiece.

*Designed with independent safety circuit,electricity could be shut down automatically when the IPL power is to high.

*Emergency stop switch,shut down the power in emergency

*Key switch to avoid starting the machine by any people.

*Use high quality engineering plastic frame,preventing electricity creepage.

Alarms of strong IPL;

IPL may hurt the eye or cause burns or fire,take all necessary prevention measures before operating .

Emitting too much light to one part may burn the skin which may cause pigmentation .

Do not watch the IPL light directly from the handpiece even wearing protective glasses.

Do not emit the light to the air ,keep the handpiece on the hanger when not using it .

6.Attentions after treatment

1.Not using irritative makeups

2.No hot water face wash or sauna in 7 days

3.No stimulating food or pigmentary food as chocolate,coffee,no smocking ,no drinking .

5.No scratch in case of scabbing .

6.Make a water replenishing care in 10days.