Stainless Steel Composite Panel,outdoor stainless steel composite panel,building material stainless steel composite panel
Negotiable /Ton
Min.Order:1 Ton
Stainless Steel Composite Panel or Stainless Steel Clad Plate is joint by carbon steel (base material) and stainless steel (clad material), which forms a kind of alloy-integrate of carbon steel and stainless steel.
The base material for clad plate could be common carbon steel such as Q235B, A516Gr70, 20R, Q345R, 16MnR, etc while 304,304L, 316,316L, 1Cr13 and duplex stainless could be taken for clad material. (Different materials can be cusomized according to our customers' requirements). As a kind of resource-saving product with reducing consumption of noble metal and construction cost for project, which make perfect match for low-cost and high property.
Used for decoration:
1. Thickness: 2mm – 4mm
2. Width: up to 1220mm
3. Length: up to 6m
4. Structure:Stainless steel plate + PE + aluminum sheet/galvanized steel sheet
5. Common base materials: Q235B,Q345R,20R, 20g, 16MnR, etc.
6. Common cladding materials: 304,316L,1Cr13,0Cr13, 1Cr13, 0Cr17, 0Cr18Ni9, 0Cr18Ni10Ti, 1Cr18Ni9Ti,etc.
7. Colors: nature, silver, bright silver, metallic champagne, champagne, copper, ivory, pearl white, pink, metallic grey, violet, ocean blue, jewelry blue, coffee, orange, green, Indian red, stone pattern, crisscross silver, lambency silver, natural woven stainless steel, hammer stamp, etc.
Used for other applications:
1. Thickness: Min 304+Q235B(1+5)
2. Width: up to 2m
3. Length: up to 8m
>Higher elasticity than aluminum
>High elongation and rigidity
>Lighter weight
>High resistance to corrosion
>Low cost and high property
•Curtain Wall decoration
•Advertising board
•Signboards
•Kitchen cabinets, Petroleum
•Chemicals
•Food industry
•Water and electric conservancy
•Dish head for boiler and pressure
etc.
Interface shear strength Jb,Mpa≥ | Yield point σs, Mpa | Tensile strength σb, Mpa | Ductility δ, % | Impact toughness Akv, J |
210 | Not less than standard value of base layer steel plate | Not less than standard value of base layer steel plate and not greater than ceiling limit value 35Mpa | Not less than standard value of base layer steel plate | Should comply with requirements for base layer steel plate |
Thickness(mm) | Flexural center d | excurvation, incurvation, 180º |
≤20 | 2a | No layering and crack |
SMC Products are packed and labeled according to the regulations and customer's requests. Great care is taken to avoid any damage which might be caused during storage or transportation. In addition, clear labels are tagged on the outside of the packages for easy identification of the product I. D. and quality information.
1)SMC Standard
2)Customization
For more details, you can visit our official website: or you can scan our QR code here.