Rated voltage:AC/DC95-265V(Only Casting alumimum Cover),DC24V

Rated torque:10N.m

Installbelow (rated torque*0.75) N.m valves: 2-way, 3-way valve

Wiringand feedback model: KT32S

High performance brushless motor,Overload protection of internalmotor

Itcan be used 20,000 times.*1

Two and more actutorscan be used in parallel

need to install protective device for the actuator                         

and explosive environment                                                             

  Hole deepness                                        ≤17mm(Female octagonal)/6.5mm(Male square)            

  Weight                                     ABS material 0.62kg,Casting alumimum 0.82kg                                 

DC24V DC12V series electric actuator wiring:

Control instructions:

* If SW is disconnected;the actuatorwill drive valve close clockwise.

When the valve is closed completely, 5 is connected with 6 ,giving signal of closing

* If SW is connected,the actuatorwill drive valve open anticlockwise. When the valve is open completely,

 5 is connected with  4 ,giving ignal of opening.

*  Notice 1: 5 is not connected with 4  6 ,when the actuator is running.

 * Notice 2:The feedback signal is a little earlierthan the actual position,so pleasedo not cut power,

when you get the feedback signal.

 Pov valve industry (Shanghai) Co., Ltd. after many years of field experience, R & D and design of products to meet the

stringent requirements of today's industrial processing fluid, by creating the most value of quality products, providing personalized service and on-time delivery principle, we gained good reputation. Our success is built on integrity, the full

range of control valve. Main products: pneumatic control valve, electric control valve, a valve, pneumatic angle seat valve, pneumatic diaphragm valve, electromagnetic valve etc.

 10nm electric actuator mounting with plastic ball valve, 2 way ball valve, 3 way ball valve; 

Diagram1 UPVC plastic ball valve+bracket assembly

Diagram2 3piece stainless steel ball valve assembly

Diagram3 3piece stainless steel 3way ball valve assembly

Installed valve technicalrequirements

1.When installing ball valve, the max torque ≤15N.m.If the ball valve is out of operationfor a long time,

and the torque value of first on or off is the max torque. Or you can choose ball valve with elastic sealing.

2.  When installing butterflyvalve, the max torque≤13N.m.Because the torque value will increased by 10-20%

after installing.

3.When installingdirect mount model valve, the hole deep ≤17mm.It requires cutting if the output shaft is longer

than 17mm.

4.  Pls pay attention to the following items if you install the bracket and coupling by yourself:

*  The intensity of bracket shouldmeet the using requirements: the bracket twisting extent≤0.2mm in the process

of on or off.

*  The parallelism of bracket ≤0.5mm.

*  When processing the shaft hole at both end of the coupling,it is necessary to ensure the accuracyand concentricity.

The purposeis to make sure the mechanical hysteresis ≤10°,otherwise it will cause the actuator unable to work.

5.  Screwshould be installedspring washer,flat washer, and we suggest you daub some glue cement around the screw

in case of screw loosening.

6.  After installation, user should switch the valve on and off one time with handle device first.     

Modifying the valve after make sure it works well.

Thank you very much for your checking here,

Any interesting in our valves please feel free to contact me leave a message or email.