Product Details

Ozone system home facial steamer beauty machine BD-P004

Product features:

1. All detachable elements make you feel more convenient to replace it. Cool & warm tanks can be washed. It can kill bacteria and remove inflammation.

2. Cold water tank is separated from hot water tank, which has been improved much from traditional cold-hot double spraying. Thus cold spray and hot spray works respectively excellently through their own channel, not affecting each other.

3. Adopt imported parts, never attenuate. Don’t do any harm to atomization slice, titanium alloy atomization slice. Atomization time is up to 10000 hours.

4. Stainless steel heating pipe never rusts.

5. Adopt European water level detection mode----No water, automatically cut off electricity.

6. Sufficient cold spray; cold and hot spray can use at the same time to form warm spray.

7. Nice, elegant and easy to operation.

Main Technical Parameters:

Rated voltage	110/220V	Maximum power for hot spraying	450W
		Maximum power for cool spraying	50W
		Maximum power for warm spraying	500W
Maximum volume of hot tank	150ml	Hot spraying time	15 min
Maximum volume of cold tank	150ml	Atomization quantity	0~400ml

Procedure for installation and operation

1. Put the machine on the smooth table.

2. Place the spray pipe to the vapor’s exit.

3. Press the hot water cup upward and then screw it.

4. Fill water into the hot water cup from the hot-spraying water inlet until the water level gets close to the high limit for water filling. So it is with cool water tank.

5. Plug to power, press the switch to begin the operation.(Attention: The machine will utter alarm sound when you turn on hot spray switch if there’s no water or too much water in the hot cup.)

Attention for operation

1. Don’t place the machine upside down or tilt it when it is in operation. Don’t operate cold spraying or hot spraying when there is no water. Don’t use water to wash the machine. Change the water inside the cold water tank and the hot water tank and clean them frequently, and power plug must be unplugged before water changing and draining. Drain all the water out of the machine if it is not used for a long time.

2. In order to avoid danger, the water level must not exce4ed the hot wate4r cup’s high limit or water filling. Please don’t take down the spray pipe during the runtime.

3. Never pour the herbal medicine, essence and so on into the water tank directly. Or else it will damage the instrument.

4. Press the hot switch and cool switch for warm vapor.

Analysis of Common Failures

Vapor Steamer	Phenomenon	Source of trouble	Solution
Troubleshooting for cool vapor	There is air flow but no vapor at all.	Cool vapor doesn’t light up.	Add water to minimum water level, turn on cool switch.
		Atomization slice is aging.	Replace atomization slice.
		The water is too hard.	Change the water or drip minim vinegar.
		Oil stain or soapsuds float on water.	Clean the water tank, drip minim vinegar.
	There is vapor but no air flow at all.	Blower is damaged.	Change the blower.
		The water level is too high.	Discharge some water.
		The water level is too low.	Pour some more water.
Troubleshooting for hot vaporization	There are sounds but no heat.	The water is too pure.	Use tap water.
		The water level is too high.	Discharge some water.
		The water is too turbid.	Clean the unit and replace with clean water.
		There is scale and oil dirt at the root of the heating tube.	Loose and take out the cup to clean it.(See the bottom of this instrument)
	No heat no sounds	Hot vapor doesn’t light up.	Turn on the switch..
		Too little time, water isn’t boiling.	Wait for several minutes until the water is boiling.
		Heating tube is damaged.	Change the heating tube.

Specification:

Voltage:110V/220V

Power:450W

G.W.:2.5kg

Package: 27*16*26cm