Removing the Helicopter from the Transmitter Case:

Operation:

1. Remove the helicopter from the Controller Case.

2. Unfold the tail of the helicopter.

3. Lift up the blades of the rotor

4. Make sure the transmitter and the helicopter are set to the same band

5. Make sure the transmitter is off (Power light indicator should be unlit) before turning on the helicopter. The throttle on the transmitter should also be all the way down.

6. Place the helicopter flat on the ground with the nose of the helicopter facing away from you.

7. Do not stand too close to the helicopter before flying. (at least 1m away)

8. Check to see that there are no other people, animals or obstacles close by

9. Turn the transmitter by switching the Off/On switch to the On position. The power LED will turn on (If the power LED on transmitter begins to flash - this means the batteries are low and need to be replaced)

10. To ascend the helicopter slowly push up on the throttle until the helicopter begins to ascend.

11. Use the controls on the transmitter to control the helicopter

Note:

1. USB indicator will not bright during charging, and red light will be on after full charge. 2. When helicopter is switched on, blue and red light will blink alternately. 3. Helicopter should take off on hand due to its low level balance.

About US:

Our factory is specialized in R/C TOYS(Include helicopters, Quadcopter,Car,Boat and so on) with more 10 years experience in this field. With the principle of "quality first, reputation first, service sencerity, the customer first", Look forward to cooperate with you all along!

About the Orders: 

1, Small orders and sample orders are welcomed.
2, Offer one-stop service for your ODM and OEM design.

About the shipment:

Certification
All products hold CE / RHOS / EN62115 / Non-phthalate / ASTM Certification.

Contact:Cindy
Tel: 0086-0754-88096815
Mobilephone:86-13413407228     
Skype: dowellin005