Description:

   SPC-1001 polyurethane adhesive cures fast with good adhesion and excellent  

   weather resistance.

   It is developed from imported raw materials, adopting the latest eco-friendly  

   international formula and advanced technology.

   It is a single-component polyurethane adhesive that is superior in performance,

   convenient in use.

   This adhesive is tested to be eco-friendly, light smell, high viscosity, good cut and  

   peel strength, heat resistant, anti-aging, It can resist water, oil dirt and eroding after

   the adhesive film foamed and solidified.

  Application:

   SPC-1001 series single component polyurethane adhesive is widely used in  

   sandwich panel manufacturing, applied by machine or by hand. 

   It can be used for bonding a variety of substrates, including plastic, sponge, leather,  

   metal, paper faced gypsum board, calcium silicate board, PVC, calcined magnesia,  

   rock wool, paper honeycomb, aluminum honeycomb, polystyrene foam, XPS

  extruded board, polywood, MDF, melamine paper board, phenol formaldehyde

   foam, etc.

   It is widely applied for door manufacturing, light-weight building materials, refrigerator,

   purification equipment, etc.

  Package:

   Package A is 25kg/plastic barrel;

   Package B is 200kg/iron drum.

   One 20' container loads 720 barrels/90 drums/18 tons

  Application instruction:

  1. Clean the target material surface.

  2. Evenly spread the adhesive, about 150g/SQM.

  3. Cover the material by raising pressure(about 0.5-1.0kg/cm2).

  4. Release the pressure after adhesive solidified.

  5. Wash the tools with acetic ether solvent.

  Note:

  1. Must press the target material within the adhesive active period, but not

  after the solidifying;

  2. Press time: about 4 hours in summer, 6 hours in winter, 24 hours  

  to reach the best intensity. To short the time, some water can be  

  sprayed on the adhesive.

  Storage:

  Stored in warehouse or indoor, keep sealed, shelf life is not less than 6  

  months.The rest glue should be sealed with cover to avoid solidification.