Realan Switch Power LR-FLEX300W

1. INPUT

1.1 VOLTAGE

1.2 FREQUENCY

      47-63 Hz

1.3 CURRENT

1.4 INRUSH CURRENT

      60A/220V at 25°CCOLD START

1.5 EFFICIENCY

      MIN65%AT FULL LOAD 220Vac 50Hz

2. OUTPUT

2.1 OUTPUT POWER

       200W (MAX).

2.2 VOLTAGE

NOTE:

1,The continuous max. DC output power shall not exceed 200W.And+5V,+3.3V total output power must not exceed 100W.

2,A 0.1uF ceramic disk capacitor & 10uF electrolytic (low ESR) capacitor should be putacross the output terminals during ripple & noise measure. The oscillo-scope bandwidth set at 20MHz withco-axial probe.

3,Regulation load must within 30% to 70% of maximum load.

4,AMBIENT TEMPERATURE 25°C.

3. PROTECTION

3.1 OVER LOAD PROTECTION

3.1.1 120-160% of maximum power.

3.2 SHORT CIRCUIT PROTECTION

      All output to ground.

NOTE :After protection active all output will shut down .After shut down the power supply shall return to normal operation.only after the fault has been removed and the remote signal reset for a minimum 1 second (or the AC remove for 10 second).

4. TIMING SEQUENCE

4.1 TURN ON TIME

      900mS MAX

4.2 P.G Delay time

      100~500mS

4.3 P.F time

      1mS MIN.

4.4 Hold up time.

      15mS MIN.

5. TEMPERATURE CHARACTORISTICS

5.1 OPERATION AMBIENT :

      +10 to +40°C.

      20~85%

5.2 NON-OPERATION AMBIENT:

      -40°Cto +70°C.

      10~90%

6. SAFETY REQUIREMENT

6.1 HI-POT TEST

      Vac =1500 Vac Current limit 10mA

6.2 GROUNDING TEST

6.3 Isolation test

7. ELECTROMAGNETIC COMPATIBILITY (Optional )

7.1 Meet with the EMI standards.

8. Burn-in

      Full load,2 Hour