Specifications

Fish Feed Pellet Rotating  Dryer

Basic Structure of the Equipment :

1 cylinder

2 front roll rings

3. Rear roller circle

4 gear

5. Retaining rollers

6. Trailer rollers

7 pinion

8. Discharge section

9. Yang plate

10. reducer

1. motor

12 hot air channel

13. feed chute

14. furnace and other components

The equipment can be designed according to user needs additional gas furnace, the combustion chamber or supporting the elevator, belt conveyor machine, quantitative feeder, cyclone dust collector, induced draft fan and so on.

Working Principles:

The equipment Is the wet material to be dried by a belt conveyor or bucket elevator to the hopper, then by feeding hopper feeder through a pipe into the feed end. Feeding pipe slope is greater than the material's natural inclination to the smooth flow of materials within the dryer. A dryer cylinder is slightly inclined to the horizontal rotating cylinder. Add material from the upper end, the heating medium from the low-entry into countercurrent contact with the material, but also with the heating body and the material and the flow into the cylinder. With the rotation of the cylinder by gravity material than the end of the run to the end. Wet material in the cylinder body to move forward the process, either directly or indirectly got heat carrier to the heat, so that the wet material to be dried, and then in the discharge end of the belt conveyor or screw conveyor sent through. In the cylinder body wall with copy board, its role is to put the material copied up and planted, so that the contact surface of the material and increases airflow to improve the drying rate and to promote material progress. The heat transfer medium is generally divided into hot air, flue gas. Heat carrier through the dryer after the general need within the gas cyclone trap material brought down. For further reduce exhaust gas dust content, but also through the bag house or wet dust collector before discharge.

The Photos:

If you are insterested in our machines, pls contact with us and tell us the following questions :

1.The capacity you need ?

2.Your raw material ?

Our engineer will design it according to your requirement .