RUNTE cast--Chinese OEM Manufacturer Medical orthopedic fiberglass cast tape

   RUNTE cast--Chinese OEM Manufacturer Medical orthopedic fiberglass cast tape

3rd generation Orthopedic fiberglass casting tape

Character & advantage:

How to use Cast:

1) Put the pad (cotton coil or cotton slipcover) on the surgery position.

2) Wear surgical gloves.

3) Select proper specification according to the surgery position.

4) Immerse the roll in room temperature water(21-24°C) for 4-6 seconds and squeeze it 2-3 times firmly. If the water warmer than 21-24°C shortens the immersing time, while cooler than 21-24°C water lengthens the time.

5) Enwind spirally; Overlapping the previous layer by one-half or two-thirds of the roll width. To maintain proper tension is very important and take care to avoid excessive tightness. The strength can be determined by the number of layers used. Just 3-4 layers provide a string non-weigh-bearing cast and 5-6 layers are typically adequate for weight-bearing cast.

6) Additional after the initial enwinding should be overlapped on itself to achieve good molding. Enwind the roll in 3-5 minutes after immersing in water because after that time it will be concretion.

7) Smooth and rub the surface to achieve good contact between layers. Keeping smoothness helps mold the wrap.

Allow about 10 minutes for sufficient concretion and let patients not move during this time. It could bear electric weight after 20 minutes.

8) It could be windowed, trimmed or removed with traditional cast saw equipment.

Outstanding Advantages Fiberglass Orthopedic casting tape high polymerorthopeadic bandage polyurethane resin polyester casting tape medical consumable bandage plaster of paris bandage

vExcellent X-Ray Radiolucency

vGood air-permeability

vHigh strength and light weight

vEnvironmental friendly material

vEasy Operationn and Remove

vRemove generate lower dust than plaster cast

Specification of Orthopedic casting tape 

Operation F  Fiberglass Orthopedic casting tape high polymerorthopeadic bandage polyurethane resin polyester casting tape medical consumable bandage plaster of paris bandage

v Use the protective padding or stockinet on the fixed part

v Wear surgical gloves, select the roll of proper size

v Immerse the cast in room temperature water (21-24degrees) for 4-6 seconds and squeeze it 2-3 times

v Wrap spirally, overlapping the previous layer by one-half or two-thirds the width of the roll

v Smooth and rub the surface to achieve good contact between layers

v Cast removal: cutting by an electric cast saw