Name: spare parts 300w tronic power in dubai china elevator door inverter
Brand: TOP GIN
Availability: InStock

Product Details

High frequency vector inverter

Control Characteristics

Control mode	Sine wave PWM mode selectable by parameter setting four control modes (1) V / F control (2) V / F control attached PG feedback (3) Current speed sensorless flux vector control (4) flux vector current control PG feedback
Starting torque	150% / zero rpm (when not accompanied by PG 150% / 1Hz)
Speed control range	1: 1000 (when the PG is not attached 1: 100)
Speed control accuracy	± 0.02% (when not attached PG ± 0.2%)
Speed response	30Hz (33ms) (PG when not attached 5Hz (200ms))
Torque limit	By parameter settings can be independently set four quadrants
Torque Control	Four-quadrant operation possible (Forward Motor / regenerative reversal electric / resuscitation)
Torque response	40Hz (25ms) (PG when not attached 20Hz (50ms))
Frequency control range	0.01~1300Hz
Frequency control accuracy	Digital signal: ± 0.01% (-10 ℃ ~ + 40 ℃) analog signal: ± 0.1% (25 ℃ ± 10 ℃)
Frequency setting resolution	Digital signal: 0.01Hz Analog signals: 0.03Hz / 60Hz * (12bit)
Frequency output resolution	0.01Hz
overload	150% of rated current 1 minute PER10MIN @ 40 ℃ above
Analog frequency setting signal	DC-10~+10V,0~10V(20KΩ)4 ~ 20mA(250Ω)
Acceleration and deceleration time	0.01 to 6000.0 seconds (four groups of acceleration, deceleration time set individually)
Brake torque	Approximately 20% additional Brake up to 150%
Run / stop setting	Operator, RS232, RS485 / 422, the control circuit terminals, 12/16 BiT binary signal
Protective function
Motor protection	Electronic thermal relay protection, under phase protection
Instantaneous overcurrent	200% of the rated current of the motor free stop
Fuse protection	Motor stops after the fuse blows freely
Overload	Motor freedom stops at more than 150% of the rated output current of about 1 minute PER10MIN @ 40 ℃
Overvoltage	Main circuit DC voltage of about 220V class 400V, 440V 800V class about free stop over motor
Low Voltage	Main circuit DC voltage of about 220V class 200V, 440V 400V class about freedom following motor stop
Instantaneous power compensation	After the operation mode selection within 2Sec blackouts continue to operate (external capacitor)
Fin overheat	Thermocouple Protection
Stall prevention	Acceleration and deceleration, stall prevention operation
Ground protection	Electronic circuit protection
Charging indicator	he main circuit DC voltage above 50V charging indicator "light"
Vibration	20Hz below 1G, 20 ~ 50Hz when 0.2G
Efficiency	Pf>0.95&η>0.95@40℃ above

[SIZE]