dream color addressable digital led strip 32led/meter strip 

Specification

These LED strips are fun and glowy. There are 32 RGB LEDs per meter, and you can control each LED individually! Yes, that's right, this is the digitally-addressable type of LED strip. You can set the color of each LED's red, green and blue component with 7-bit PWM precision (so 21-bit color per pixel). The LEDs are controlled by shift-registers that are chained up down the strip so you can shorten or lengthen the strip.

Main Features

Flexibility, can be bent at any angle. 
Compact size, It has a super slim shape with the width only 14mm. 
Abundant color modes, up to thousands of color change modes can be put in the programs. 
Work with LED control system could get Jumping, fading, flashing, dimming mode. 
Users can cut the ribbon every 3 LEDs. 
Continous light connection, It can run 15 meters continously.

Other Features

1. Vivid color effects, all individual LEDs are red, green and blue 3-in-1 type.
2. With help of the built-in IC on ribbon, the LEDs long life span and color consistency can be maintained. .
3. Long life, light source can last more than 50.000 hours.
4. Easy installation using plastic clip to fix it.
5. Low voltage, safety, stability.
6. Low energy consumption, super-bright LED
7. Resist vibration, free maintenance.
8. Waterproof, suitable for indoor and outdoor applications.
9. ECO-friendly, No mercury, no UR and IR.

Installation Notice

1) Make sure the connection is correct according to the diagram.
2) Pay attention on the parameters limit on the above form. DO NOT run over the peak value.
3) Keep the surface of installation clear and level avoid breaking off.
4) Avoid the crook area is the just the position of LED and other components, in order to protect the product and extend the life span of the product.

5) in installation please note that led strips the article input and output port

6) when a current in please make sure the input voltage for the article lamp whether DC12V or DC5V

7) the outdoor when using note, the led strips of article exterior waterproofing if there is any breakage.

8) article if the product length needs to change, please in the main light input and add the article input decoder.

Application

 The product is widely used in building outline lights, entertainment quasi-decorative lighting, advertisement decorative lighting and so on. The product is waterproof performance, low-voltage DC power supply safety, convenience, variety of LED colors, colorful. By the FPC circuit board, LED lights, made of high-quality silicone sleeve. UV resistant for outdoor use may be aging, yellowing, high temperature and other advantages.

Notice

Make sure the connection is correct according to the diagram.

DO NOT run over the peak value.

Keep the surface of installation place clear and smooth, avoiding the strip fall off. DO NOT press the LED

DO NOT attempt to make sharp bends with the strip.

DO NOT install where water or high humidity  may be present without further protection.

3M tape used only for indoor, when the strip installed outdoor, please use fixed slot.

Away from strong acid or strong alkali.