Product Details

Product Name: Easy to install wireless ceiling roof PIR sensor

Product Description:
Adopting advanced digital signal processing technology, Compounding of high precision
passive infrared detector and logical digital circuit design, feature intelligent power
save, auto- temperature compensation, low battery alarm and so on. It emits wireless
digital signal to start the control panel for alarm through detecting human being
body infrared heat. Nice looking, Reliable and fine quality. It can be compatible with
many other control panel.

Function:

1. Tamper switch: it will send alarm signal if cover is disassembled
2. Preset coding with the control panel: Switch the protection zone to “ON”, press the
tamper switch and send wireless signal, the control panel sounds, it means that
coding is completed matched.(refer to the coding program of control panel operation
instruction and relative detector)
3. Low battery alarm: when battery is low voltage, the human being body moving, LED flashes five times. In static environment ,it is not activated.
4. Coding address: preset by manufacture or by user.
5.Protected time choosing: 3 seconds or 30 seconds, it is preset by playing pins.
6. Compatible with many control panel.

Specification:

Power supply: 9VDC Li-ion & manganese battery 500mAh
Working current: static < 30µA; alarm < 16 mA
Wireless parameter: frequency 315MHz or 433MHz, Transmitting distance >150 m
(wide area without interfere)
Detecting range: high 2.4m from ground, covered diameter:7.3m, high 4.5m,
covered diameter: 9mWorking condition: working temperature: -10ºC~55ºC
Product size: Φ96*25mm

Installation:
1, Installing guide
Open the cover, connect the battery, than the detector starts to work.
Press tamper switch to transmit the signal to match coding of the control panel
Close the cover, when installing it, please learn the following diagram.
When the power is on, the LED flashes for about two seconds, the detector will continues to delay for about three seconds or thirty seconds (it depends on protecting time
choosing),than it enters the activate situation. If intruder enter protection area.
The detector immediately sends out wireless alarm signal.
2. Usage Walk test: to set the protecting time choosing to 3 seconds by playing pin, simulated as intruder go into the protection area, the LED flashes for about 2 seconds, the
detector sends out the wireless signal, meanwhile, the control panel should receive
the signal. After walk test, it tested well, please set the protecting time choosing
to 30 seconds so as to start to work.
Note: When setting the protecting time, please shut off battery power and press
tamper switch once.

Caution:
Install the detector to the proper place where intruder must enter.
Do not face the detector to any area where window, lamp-house, heat thing and so on.
It is used for indoor,not for outdoor .When installing, do not drop down or hit the detector so to avoid the internal infrared sensor. Do not touch the sensor lens so to avoid the detecting distance and sensitivity. Have termly walk test