100Levels Remote Control vibration dog barking collar pet trainer
USD $18 - $25 /Set
Min.Order:500 Sets
Shenzhen Jianyexing Technology Co., Ltd.
Remote Control No Bark Training Shock Collar Dog Anti Barking Control
Remote Electric Rechargeable One Pet Dog Training Shock Vibration No Bark Collar
Smart Dog In-ground Electronic pet Fencing System Invisible dog fence for 2dogs
Multi-Dog Training System Remote Remote Control Collar Pet Training System
Features:
1. 100 levels of vibration.
2. 100 levels of static (optional).
3. The levels can be altered by use of up & down button.
4. A tone button activates a tone on the receiver.
5. This system is used for 2 receivers.
6. The receiver will TURN OFF if it is unused for 4 minutes.
7. Any movement will activate the receiver into STANDBY MODE.
8. The transmitter will go into STANDBY MODE if there is no operation after 20 seconds and turn off after 2 minute.
9. Adjustable belt length, maximum diameter of 18cm, two pairs of metal prong (short/long) to suit dogs with varied fur thickness.
User Manual for Transmitter:
1. To install the batteries, open the battery cover, which is at the back of the transmitter.
2. Install the battery (2 x 4LR44/ 6V) in the transmitter and ensure the polarity is correct.
3. The transmitter will be TURN ON automatically.
4. Press the buttons one by one - the LCD images will change.
5. Press the up and down buttons on right hand side to set level.
6. The LED light can be used for giving training signals.
7. The transmitter will go into STANDBY MODE if not operated for 20 seconds and will TURN OFF if not operated for 2 minutes.
8. In STANDBY MODE, press any button (except LED light button) to wake it up.
9. To TURN ON the transmitter, hold mode button for at least 5 seconds.
User Manual for the Receiver:
1.To install the batteries
2.Remove the cover
3.Install the batteries (2xAAA 1.5V), make sure the polarity is correct
4.There is a beep right after installing the batteries in the receiver
5.Go to the transmitter and choose 1 or 2 channel to encode by pressing the channel button 1/2 in the transmitter
6.Then press the LAUNCH button on transmitter immediately
7.The receiver will beep - it is now encoded to the transmitter
8.Replace cover and tighten metal probes
If you need more information about an item, call us. If you can't find an item, call us.
Prompt, efficient and friendly service is our hallmark, and we're anxious to prove it to you.
You can reach us Monday through Friday 8.00am - 6pm.
Mob: +86 18682245181
Tel:+86 0755-27589087
Fax:+86 0755-27570739
If you would like more information or to place an order please contact us : sales03 at .
For wholesale enquiries please contact us : sales03 at .