Product Details

EMM-15-148 metal roof panel forming machine

Product Description

metal roof panel forming machine

Basic Information:

Material Name:Galvanized sheet

Thickness:1.2mm

Products cutting error:≤±2mm

Floor area:12m×2m×3m (L×W×H)

Voltage:380V,50HZ, 3 phase

No.	Name	Specification	Quantity
1	One ton of manual decoiler	1. Material thickness:0.27-0.8mm	1set
		2. Material width:20~350mm
		3. Feed speed: follow-up
		4. Rated load:1T;limit load:1.5T;
		5. Steel volumes of hole:508mm;OD:1350mm;
		6. Tensioning type:Manual screw tensioning
2	Rolling forming parts	1. spindle:dia50mm, 40Cr,The drive shaft	1set
		2. forming passes:14;fame:Guide pillar arch structure
		3. roll speed:0~15m/min
		4. Siemens three-phase motor,11KW four level one set
		5. drive:Turbine worm reducer
		6. protection mesh enclosure
3	Tracking cutting machine	1. Cutting type:Hydraulic cutting	1set
		2. control type:Servo trace ,Digital fixed-length
4	Automatic pallet loading	1. Photoelectric sensor;
		2. Cylinder control,Cantilever material;
		3. Automatic pallet;
5	Computer control system	1. transducer:Siemens or mitsubishi	1set
		2. PLC: Mitsubishi and Siemens
		3. encoder:Omron(2000P)
		4. touch screen:Mitsubishi or Siemens
		5. A key remote control, automatic stop

Manual feeding→Feeding guide→roll forming →straightening→Track to cut off→Automatic material pallet

This production line can automatic continuous rolling forming ,track scale cut off and etc for the plate, ensure the continuity of production and often can up to max. Steel strip coil are on manual feeding shelf, enter into roll forming machine for forming, and then cut the knife moulds to cut the product for length.

NO.	Device name	Quantity
1	One ton manual decoiler	1set
2	Guide rack	1set
3	the host(Including roller, cooling system, protective cover)	1set
4	5 roll Straightening frame	1set
5	Trace length to cut off the table(Including the moulds)	1set
6	Automatic pallet loading	1set
8	Computer control system	1set