HB05 Mini Size UL CQC Certified Snap Action Thermal Protector

Property:
1. Voted current(COS=0.7)
   DC24V-10A,AC250V-5A
2. Disconnect temperature: 30 ° ~ 155 ~ 20 °c ,reset temperature 110 degrees Celsius (see drawing).

3. Ant-tension test: Product test pins should with no fault, sliding out when bearing >=20N.   
4. Insulation voltage:
   a. Products in the lead when disconnect between AC660V shall withstand, 1min without breakdown
       flashover phenomenon;
   b. Product leads and insulated shell, between AC1800V can withstand 1S without breakdown flashover phenomenon.
5. Insulation resistance: under normal conditions, fuses and insulation shell insulation resistance in 100M Ω above.
   (used for DC500V meter)
6. Contact resistance:Product contact resistance shall not be more than 50mΩ.
7. High temperature resistant test: The action temperaturethe should keep in 96h in temperature of 50°C
   rated movements in air environment.
8. Low temperature resistance test: product should keep in 96h when in air environment - 40 ° c
9. Ant-vibration test: thermal protectors shall withstand amplitude, frequency changing 1.5 mm 10 ~ 55Hz,
   scanning change cycle 3-5 times/min, vibration directionX,Y,Z, in each direction, each successive 2h vibration.
10. Drop test: products high free fall from 0.7 m.
11. Compression test: products shall stand 1min in100N static pressure.
     3.7,3.8,3.9,3.10,3.11should meet the following requirements:
     a.Disconnect temperature charges in the initial value should be within +7℃
     ntact resistance should be below 100mΩ;
     c.appearance should be no obvious deformation;
     d.wires should without cracking damage.

Life Cycle:
    Products in the rated voltage, current, power factor for 0.7 conditions, plus 4,000 times that the action of heat, should
    satisfy as below:
    a. Disconnect temperature changes in the initial value should be within + 5 ° c,
    b. Contact resistance should be belowin100mΩ continue experiment in 6000times after action.  

Other items:
    Disconnect the temperature detection heating rate should be controlled for 1 ° c / 1min, Use process cannot bear
    strong impact and stress.

Certifications:
    CQC Certification NO:CQC06002017310
    CB Certification NO:CN8029
    UL Certification NO: 258703
    ISO9001 Certification NO:0105Q1274ROS/3200