1-This bar included 48pcs LED 5050 RGB with lens

2-Cuttable each section of 10cm (3LED)
3-Each LED covered by a optical lens, beam angle 160 Degree, An-ti UV.
4-PU glue injection IP68 waterproof
5-Good waterproof connector
6-The Aluminum size is 1150mm, PCB size is 990mm, there is a gap on each side of the bar.

You can see each LED chip with a optical lens covered, it can protect the LED chip, incase the water inside,

and the beam angle is 160 Degree, also with An-ti UV effect

the male and female connector on both end with a very good quality, no matter can avoid the waterproof

in it, also can use in very terrible temperature, like -40C....

From this picture, you will know each this bar with IC chip for control, per 3LEDs & 1 IC,

that means per 3LEDs each group, you can cut the rigid bar per 3LEDs(6.25cm).

This rigid bar also with very good waterproof effect, no matter the lens proect LED chip, 

each bar mounted in a aluminum profile, and with PU silicon glue covered the whole bar.

even the both end, in weld pad, also have full silicon protect.

addressable WS2812b digital led bar, 1IC&1LED

16 pixel DMX led tube