Parameter

Type

Condition/Note

Operating supply voltage

DC 1.8~3.6V

Central frequency

2433MHz

Can be programmable to other frequency in bands 2400~2483.5MHz

Frequency accuracy

±30KHz

Modulation format

GFSK/2-FSK/ASK/OOK/MSK

Programmable

Transmit power

-30~+1dBm

Programmable

TX current consumption

<25mA

Po=+1dBm

Receiver sensitivity

-105dBm

2.4Kbps

RX current consumption

<15mA

2.4Kbps

Sleep State current consumption

<2uA

Refer to IC operation states

Data rate

1.2~500Kbps

Programmable

Spurious emissions and harmonics

< -30dBm

TX power +10dBm.

Communication distance

>80m

2-FSK modulation, 2.4kbps data rata, +1dBm output power.

Antenna impedance

50ohm

PCB

General Description

VT-CC2500-M1 is based on RF transceiver CC2500 of TI Chipcon,it’s a small size and low power consumption module. CC2500 is a low-cost 2.4 GHz transceiver designed for designed for very low power wireless applications. The circuit is intended for the 2400-2483.5 MHz ISM (Industrial, Scientific and Medical) and SRD (Short Range Device) frequency band. The MAX RF output power can be set as high as +1dBm, with data rate as high as 500Kbps. The module integrated many RF functions thus you can use it conveniently and reducing your development time.    

Features

l  Central frequency is 2433MHz, Frequency bands: 2400~2483.5MHz

l  Programmable output power up to +1dBm for all supported frequencies,the communication distance is above 80m in sight .

l  High receiver sensitivity down to -105dBm(at 2.4Kbps data rate)

l  Programmable baseband modulator with GFSK/2-FSK/ASK/OOK/MSK

l  Programmable data rate 1.2~500Kbps

l  Separate 64-byte RX and TX data FIFOs.

l  Built-in CRC check ensure data transmission reliably.

l  Support carrier sense indicator and digital RSSI output.

l  Low current consumption with receive mode <15mA, transmit mode at +1dBm output power <25mA

l  Low current consumption at power down state <2uA

l  Wake-on-radio functionality for automatic low-power RX polling

l  Integrated analog temperature sensor

l  Efficient SPI interface, all registers can be programmed with one “burst” transfer

l  Small dimension: 20.8mm×17.0mm×2.4 mm

l  Operating supply voltage:1.8~3.6V DC

Applications

l  Logistics Tracking System, Warehouse patrol, Electronic label.

l  Replace RS232 and RS485 in data transmission

l  Industrial monitoring and control in data acquisition

l  AMR – Automatic Meter Reading

l  Home and building automation

l  Consumer Electronics products of wireless control

l  Wireless alarm and security systems

l  Wireless sensor networks

General Characteristics

Test operating conditions:Ta=25°C,VCC=3.3V if nothing else stated.

Note:

1.  The module transmission data rate will affect transmission distance ,the higher the data rate , the closer the distance, and the lower the receiving sensitivity.

2.  The supply voltage to the module will affect TX power, in the operating supply voltage range, the lower the voltage, the lower the TX power.

3.  The module central frequency will change as the operating temperature change, use it under suggest temperature, the module can work well.

4.  The antenna will strongly affect the communication distance, please select matched antenna and connect it correctly.

5.  The module mount will affect the communication distance.

Operating temperature

-20~+75 °C

Storage temperature range

-50~+125°C

Dimension

20.8 mm×17.0 mm×2.4mm

See more in PCB description