Roof Waterproof tape

The specially formulated rubberized asphalt adhesive seals around fasteners, allowing no water to penetrate and get to the substrate.

Highly conformable and flexible-Can accommodate settlement and shrinkage movement.

Long-lasting waterproofing protection-Both the aluminum surfaced polyethylene film and pure alu surface with the specially-formulated rubberized asphalt components create a water and moisture barrier that does not degrade from the effects of the environment.

XUNDA700 with aluminum backing reflects sunlight, protecting substrate from ultraviolet radiation.

Application

a.) Measure length of Denso Flashing Tape required and cut from the roll.

b.) Peel a short length (about 4 inches) of the release film from one end of the length of tape.
c.) Position this end (compound side down) onto the dry primed surface and press down firmly with hand or roller.

d.) Ensure the tape is evenly pressed down avoiding creases or air pockets.  It is very important to press down the edges and ends of the tape.

e.) Continue along the length of tape peeling off approximately 8 to 12 inches of release film as     application proceeds.  It is recommended that only short lengths of release film are removed     at any time to avoid contamination of the compound with dirt and dust.

 It can be used for  Doors & Windows , Roof Patch ,Gutter Patch, Skylights, Valley Repair ,Metal Patch Metal Roofs, Flat Roofs, Trucks, RV’s ,Mobile Homes, Trailers.

Besides ,it also could be used for  Exposed steel pipelines