Specifications

metal rfid card reader
125khz
EM card reader
3-10cm proximity range

125khz waterproof metal rfid card reader with WG26/RS485

 

Brief introduction

JY-RF006MF is a long range metal rfid card reader. With 125khz frequency, it can allow fast recognition and reaction. Its reading distance can reach 10cm, allow users pass through conveniently.  When the card approach the reader, the red light turn into green, after glinting to turn red color again, the buzzer sound shows transiting data. It has 500ms proximity time distance for card proximity. After finishing card proximity, if the same ID card is still in the proximity range, reader will not send out the data, neither giving any sound hint. But for Different ID card entering Proximity Area, Reader can do response continually and send out the data.

 

Product Highlights

> WG26/RS485 output                                                    

> Reading distance: 3 to 10cm                      

> Waterproof metal casing                                                                      

> Size: 120*56*18mm

 

Product specifications

Technical parameters

Support	EM-ID,M1-mifare card,15693card,and 1443A,1443B Card
Reading Range	5 to 10CM
Work Voltage	DC12V±10%
Static Current	≤30mA
Ambient Temperature	-30°C~50°C
Ambient Humidity	10%~90%
Size	120 *80*25mm

 

 

Wire Connection

 

WG26/34	RS485	RS232
Red DC 9V-16V	Red DC 9V-16V	Red DC 9V-16V
Black GND	Black GND	Black GND
Green  D0	Green D0	Green RX
White D1	White 4R-	White TX

 

View of Product

 

Installation:
Using “+”type screw driver to loosen the screw between the panel and motherboard. And
then embed the motherboard to the side wall with the plastic plug and screws.

 

Wire Connection:
WG26/34                             RS485                                    RS232
Red: DC 9V-16V                  Red: DC 9V-16V                    Red: DC 9V-16V
Black:GND                           Black:GND                               Black:GND
Green:D0                            Green:4R+                               Green:RX
White:D1                              White: 4R-                              White:TX
Blue: LED
Yellow:BEEP
gray :Door Bell
purple: Door Bell

 

Notice!
1. Confirm the electric voltage (DC12V) and differentiate positive anode and cathode of
power supply
2. When external Power is used, make sure sharing the power with Controller Box or using the
same GND
3. The wire connects reader to controller, advise use 8 cores stranded twisted pair
cable(among them, three strands are spare, if no need reader show illegal card s by sound
and light, LED wire can not be used, data wire Data1 Data0 are twisted pair would be better,
we suggest sectional area are 0.22 square millimeter at least. The length should not exceed
100meters.

 

 

Our Service

 

 

 

Company Show

 

 

Any Questions? Contact Us