Specifications

Economical standalone 125khz rfid reader with WG26/WG34 optional
Working current: <100mA
WG26/34 optional

Economical Standalone 125khz rfid reader with WG26/WG34 optional

 

Brief introduction

JYC-18M is a good standalone 125khz rfid reader with WG26/WG34 optional. With 125khz frequency, it can allow fast recognition and reaction. Its reading distance range 3-5 cm, allow users pass through conveniently.  When the card approach the reader, the red light turn into green, after glinting to turn red color again, the buzzer sound shows transiting data. It has 500ms proximity time distance for card proximity. After finishing card proximity, if the same ID card is still in the proximity range, reader will not send out the data, neither giving any sound hint. But for Different ID card entering Proximity Area, Reader can do response continually and send out the data.

 

Product Features

> WG26 ( WG34 optional )                                                                  

> Size: 100*100*20(mm)                                                              

> DC9~16V                                                              

> Working current: ≤100mA 

 

Product specifications

Model	JYC-18M
Color	Black / White
Voltage	DC9~16V
Current	≤100mA
Ambient Temperature	-25°C~75°C
Reading Range	5~15CM
Output Format	Wiegand26/34
Card Type	ID/Mifare card
Comunication Distance	WG≤100M,

 

View of Product

Installation:
Using “+”type screw driver to loosen the screw between the panel and motherboard. And
then embed the motherboard to the side wall with the plastic plug and screws.

 

Wire Connection:
WG26/34                                                   RS485                                                    RS232
Red: DC 9V-16V                                        Red: DC 9V-16V                                    Red: DC 9V-16V
Black:GND                                                 Black:GND                                             Black:GND
Green:D0                                                  Green:4R+                                             Green:RX
White:D1                                                   White: 4R-                                              White:TX
Blue: LED
Yellow:BEEP
gray :Door Bell
purple: Door Bell

 

Notice!
1. Confirm the electric voltage (DC12V) and differentiate positive anode and cathode of
power supply
2. When external Power is used, make sure sharing the power with Controller Box or using the
same GND
3. The wire connects reader to controller, advise use 8 cores stranded twisted pair
cable(among them, three strands are spare, if no need reader show illegal card s by sound
and light, LED wire can not be used, data wire Data1 Data0 are twisted pair would be better,
we suggest sectional area are 0.22 square millimeter at least. The length should not exceed
100meters.

 

 

Our Service

 

 

 

Company Show

 

 

Any Questions? Contact Us