Specifications

1. integral drill rod with various size
2. shank size Hex22mm(25mm) x108mm
3. durable steel material for longtime use

BESTLINK ROCK DRILL ROD( steel rod, drill steel)

 

Our rok drill rod are made of high quality and durable steel; it will not be so easy to break like others'.

 

Taper drill rod

 

1) taper angle(degree): 4.46, 6, 7 , 11, 12

2) shank size: hex 22mm*108mm/25mm*159mm

3) length: 0.4m-10m

 

Different rock formations and rock drills require different taper angles. When drilling with high impact hydraulic rock drills in medium-hard to hard and abrasive rock formations, a wide taper angle is normally used. Taper angles of 11 and 12-degrees are normally used on modern drill rigs. For low impact rock drills and softer rock formations, a narrow taper angle of seven degrees is used. A 7-degree angle can also be used if bit spinning is a problem when using 11 and 12-degree equipment. In addition, a 4,46 degree angle is ideal for soft rock when you're using pneumatic or hydraulic drill rigs - to prevent bits from spinning or becoming detached.

 

Integral drill rod

 

 

1) Different sizes available

2) 2 kinds of shank size, hex22 and hex25

3) Length under collar(mm): 400 800 1600 2400 3200 4000 4800

4) Bit diameter(mm):29,30,31,32,33,34,35,36,37,38,39,40,41

 

Integral Drill Steel is used by a hand held drill machine in Underground mining and for small hole drilling, equipped with small power rock drills, like air leg rock drills, hand held rock drills, etc. It can reduces the expense of impact energy, improves the drilling speed and efficiency, also it can be used for drilling bore hole diameter from 30mm to 41mm usually. Regarding Integral drill steels,the quality of a steel material and a tungsten carbide is very important to get good drilling performance.