TS-9506VR Matrix control YPbPr CVBS VGA Signal Transmission Receiver
USD $100 - $5,000 /Piece
Min.Order:10 Pieces
Guangzhou Baolun Electronics Co., Ltd.
TS-9506VR Matrix control YPbPr CVBS VGA Signal Transmission Receiver
TS-9506VR is a perfect Extender to transmit VGA signal source, via a single CAT5e / 6 unshielded twisted pair transmission high-definition video signal, transmission distance is up to 100 meters, supporting the highest resolution 1900 x 1200 @ 60Hz, while transmitting bidirectional RS-232, two-way infrared signals, providing long-distance transmission of video source devices and display devices, two-way control to provide a low-cost solution.
* Support VGA,YPbPr,CVBS signal output
* Support analog stereo output
* Support Bi-directional IR, RS-232 transmission
* Support for video, audio, IR, RS-232 transmission simultaneously, CAT5e / 6 cable shield maximum transmission distance of 100M.
Model | TS-9506VR | ||
VGA Video |
| ||
Interface | 15 - pinDB mother interface | ||
Bandwidth | 330MHz | ||
Signal Types | RGBHV | ||
Gain | 0 dB | ||
Signal Strength | 0.63Vpp - 0.9Vpp | ||
The Output Resolution | The output resolution. | ||
Impedance | 50Ω | ||
Return loss | <-30dB@5MHz | ||
Composite Video CV/Component |
| ||
Video YPbPr Video Output |
| ||
Interface | HD-DB15 mother interface | ||
Signal Types | Composite video CV/component video YPbPr | ||
Gain | 0 dB | ||
Bandwidth | CV: 150MHz @ -3dB | ||
| YPbPr: 350 MHz @ -3dB | ||
Differential Phase Error | 0.1°,3.58-4.43MHz | ||
When The Differential Gain Error | 0.1%,3.58-4.43MHz | ||
Signal Strength | 1 VPP: composite video (CVBS) | ||
| 1 VPP: the Y component video | ||
| The PbPr/CbCr Vpp 0.3: component video | ||
Minimum/Maximum Level | Analog signal: - 2 v/v + 2 | ||
Output Impedance | 75 Ω | ||
Return Loss | <-30dB@5MHz | ||
Audio Signal |
| ||
Interface | 5bit 3.8 interface | ||
Gain | 0 dB | ||
Frequency response | 20 Hz ~ 20 kHz | ||
Total Harmonic Distortion | 0.01% @ 1 kHz (rated voltage) | ||
Plus noise | |||
S/N | >80dB at Vin=0 V | ||
CMRR | >75dB@:20 Hz ~ 20 kHz | ||
Signal Types | Stereo (unbalanced connection) | ||
Impedance | Input: > 10 kΩ (balance or/non equilibrium method) | ||
| Output: 50 Ω (non-equilibrium connection) | ||
Maximum Input level | +19.5dBu, (balanced or unbalanced connection) | ||
Gain Error | ±0.1dB @20 Hz ~ 20 kHz | ||
IR Infrared |
| ||
Interface | 3bit 3.8 interface | ||
Signal Types | Input: digital | ||
| Output: digital | ||
Level Type | PLL level | ||
The wavelength | 850nm | ||
Carrier frequency | 38KHz | ||
The RS - 232. |
| ||
interface | 3bit 3.8 interface | ||
Signal Types | Digital | ||
Level type | RS-232 Level | ||
Signal Direction | Bidirectional communication | ||
Baud Rate | Min:4800bps Max:115200bps | ||
Data Bits | 8bit | ||
Stop Bit | 1bit | ||
Correction Bit | None | ||
Flow Control | None | ||
Level Delay | 500 ns | ||
Peak Level | +/-15V | ||
HDBadet Output Interface |
| ||
Interface | High Speed Rj45 | ||
Transmission Distance | Adopt CAT5e / 6 shielded wire up to 100 m | ||
Specification |
| ||
Power Supply | 12 VDC / 1.5 A | ||
Max Power Consumption | 4W | ||
Temperature | Storage, temperature: - 20 ℃ ~ + 70 ℃ | ||
Humidity | Storage, use, humidity: 10% ~ 90% | ||
Dimesions (mm) | 162(L) X 195(W) X 35(H) | ||
ITC promise the electronics yearly failure rate is less than 1%.
ITC guarantee all electronics of 3 years quality warranty.
ITC could supply 1% wearing spare parts free of charge.
ITC guarantee all loudspeakers of 6 months quality warranty.
All of quality complaint shall be attached with serial number, failure test report and photos.
All of the quality compliant shall be feedback with a solution within 48 hours.
ITC could supply circuit diagram documents for repair.