RC Simulated LED Lighting System for Helicopters and Aeroplanes

This LED system is the simulated flight LED which is used with high-technology and high brightness LED.

 Installation:

1.The Flight LED System consists of the Main Control Board,

2*always-bright white lights, 1*always-bright green light, 1*always-bright red light,

2*White Strobe , 2*Slow-Flash Red Light

2. Please set up the lights according to the following picture,so it will act like the true

plane lights. You can also fix the lights on the different positions as you like

3.Please connect the LED Leads with the Main Control Board and then connect to the power supply

only after fixing all the wires

4.Put the main control board in the cabin and fix the flight lights and wires before flying

Direction For Use:

1.The Power of the Lights can be either from the individual battery pack 4V-6V or your receiver battery

2.Although these lights use little power , we suggest you always fix a battery monitor to your receiver

and check the state of your battery before flight. Don't use the power lights if you have low battery

power or if you are unsure of the state of your flight battery .