sinter plant

Specifications

Features:

1.      Burnt lime addition:

Burnt lime addition into raw mix can increase the raw mix temperature, optimize the sintering process and ensure a stable and high productivity..

2.      Automatic weighing system:

Automatic weighing system with accuracy of ±0.5% is applied so that the operation of equipment is much more reliable and the sinter product qualification rate is stepped up largely.

3.      Thick layer sintering:

The total bed height on sinter machine can be above 650mm, which shall reduce the fuel consumption, save operation cost and lower down FeO content in the sinter product.

4.      Linear sinter machine:

Discharging mode of linear sinter machine makes that no fired raw mix will accumulate on the grate bars, thus the permeability of bedding material is highly enhanced and sinter product quality is largely improved.    

5.      Energy efficient ignition furnace:

New type energy efficient ignition furnace is designed, including pre-heating, ignition and holding section. With this furnace, energy shall be saved, operation cost shall be reduced and sinter product quality shall be improved. Moreover, this new type furnace can be fired with various gas fuels, such as pure low CV BF gas, Light Diesel Oil and LPG.

6.        Waste heat recovery system:

The waste gas from the annular cooler shall be recycled for pre-heating the raw mix in the ignition furnace and hot blast sintering. Gas fuel consumption shall be reduced and operation cost shall be decreased.

7.      Environmental protection:

ESP with high de-dusting efficiency more than 99% is used for well protecting the environment. Water treatment system ensures that no effluent will be discharged out of the plant.

8.      Automation:

Advanced distributed control systems and PLC system brings about easy operation of the plant, so that staff requirement is lessened and running cost is lowered down.

9.      Comparing with annular sintering and winch driven sintering plant:

Total investment is higher, civil work is more and construction period is longer than annular sintering and winch driven sintering plant.