Specifications

Introducation

Machine consist of uncoiler and its base, coil sheet guiding equipment, film covering device, roll forming system, post cutting equipment, hydraulic station, controlling system, supporter table.  

Introduction:

Machine consist of uncoiler and its base, coil sheet guiding equipment, film covering device, roll forming system, post cutting equipment, hydraulic station, controlling system, supporter table.

Technical Parameters:

1. Leak frame load-bearing:4T 

2. Rack: welding with 300H steel

3. The form of forming machine guiding filling: side skip

4. The form of forming machine: chain drive with wallboard type

5. Diameter of Shaft is: ø80mm

6. Chain: 0.6 inch single row

7. Main motor power:3kw double pole reduction box

8. Forming Speed: 8m/min

9. Number of tracks: 11 tracks

10. Roller material: high grade 45#steel

11. Hydraulic station power: 3kw

12. Hydraulic station oil pump: gearpump

13. Cutting type: hydraulic cut

14.  Forming Cutting blade: Cr12 

15. Heat treatment on cutting blade: HRC58°-60°

16. Thickness of coil sheet: 0.4-1.0mm

17.  Coil width of material: 1200mm

18.  Index error of length: +2mm

19.  Controlling system: PLC

Material of main equipment

• Roller material: high grade NO.45 forged steel, plated hard chrome on the surface of roller with thickness 0.05mm
• Active shaft material: high grade NO.45 carbon wrought steel at  72mm
• Cutting blade: Cr12 mould steel with quenched treatment