Specifications

roll forming machine1. Nice appearence.
2. Low noise.
3. High efficiency.
4. Good quality.
5. Esay control.

 roll forming machine

1.Leak fame load-bearing:4T 

2. Rack: welding with 300H steel

3. The form of forming machine guiding filling: side skip

4.The form of forming machine: chain drive with wallboard type, the thickness of wallboard is 12mm.

5. Diameter of Shaft is: 72mm

6.Chain: 0.6 inch single row

7. Main motor power:3kw double pole reduction box

8. Forming Speed: 8m/min

9. Number of tracks: 11 tracks

10. Roller material: high grade 45#steel

11 Hydraulic station power: 3kw

12 Hydraulic station oil pump: gearpump

13 Cutting type: hydraulic cut

14 Forming Cutting blade: Cr12 

15 Heat treatment on cutting blade: HRC58°-60°

16 Thickness of coil sheet: 0.3-0.8mm

17 Coil width of material: 1000mm

18 Index error of length: ±2mm

19 Controlling system: PLC

20 Voltage: 380V 3phase 60 HZ or at buyer’s requirement 

 

Additional info

Material of forming rollers: GCr15 bearing steel with quenched treatment

Material of cutter blade: Cr 12 mould steel with quenched treatment

 

 

Machine Type	Strip thickness	Strip width	Main motor power	Forming Speed
RSHY120	0.5-1.5mm	200-230mm	7.5KW	10-50m/min.
RSHY150	0.5-2.0mm	220-250mm	11KW-15KW	8-15m/min.
RSHY160	0.5-2.5mm	200-300mm	15KW-22KW	8-15m/min.
RSHY180	0.8-3.5mm	250-400mm	37KW-45KW	8-15m/min.
RSHY250	1.0-4.5mm	250-500mm	55KW-75KW	8-10m/min.
RSHY300	1.0-6.0mm	250-500mm	75KW-90KW	8-10m/min.