kid's alarm device
Negotiable /Set
Min.Order:10 Sets
Shenzhen Gtw Security Technology Co., Ltd.
1.,Accessories of product.
1:a transmitter
2:a receiver
3.a user manual
2:Product's Features
* Frequency : 433.92MHZ
* Transmit distance,3—5 meters
* Transmitter powered by CR 1616 button battery
* Transmitter adopt two-sided bed wetting detect sensor
* Receiver powered by 2 "AAA" batteries
*There is 3 alarm sound available, 3 pcs LED flash indicator
*4 levels alarm voice volume adjustable
3,Function specification
A:Transmitter function illustration
1,2: Head and tail bed wetting detect pin
B: Receiver's function illustration
1:LED indicator
*LED indicator will be flashing by order from top to bottom while power on, then LED off product will be into standby state. LED indicator simultaneously flashing while alarm.
2:Horn
3:Volume control switch, there is 4 levels volume adjustable.
4:Power key and alarm control key, the bottom is off, top is A/B/C three different alarm tone
5:Bracket
6:Battery cover, built in 2AAA batteries.
4.Operation instruction
1:Installed the battery of receiver by the correct way, turn on the receiver power to any grade of A/B/C, the panel led will be flashing one time from top to bottom then go into the stand by state. It will receive signal from transmitter after the LED off .
2:Short-ciruit the transmitter (bed wetting detect pin) by hand or others conductor, check if there is LED flash or not, and note that receiver should be alarm. It work proper if it can alarm and flash, LED will keep flashing once the alarm activated, please terminated flashing and alarm by power off.
3: Voice volume is adjustable while it's alarm, select the suitable level to save power, the louder voice cost the more power consumption,Vice-verse.
4: After everything is working properly, put transmitter to baby peeing place where can be detected the pee, re-turn on receiver standby, in order alarm inform parents when their's kid is peeing.
Note: When detect baby is peeing, transmitter will transmit signal about 4 seconds, send the signal interval 1 minute if there is keep detecting wet. Stop transmit signal until the transmitter is unavailable.
5.problems diagnosis and solve
1: No alarm
short-circuit transmitter detect pin, check receiver alarm or not, if installed battery for receiver and LED flashing proper, maybe transmitter battery low, please replace battery.
6,Parameters:
Frequency:433.92MHZ
Mode :ASK
Receiver distance:3-5 meters
Transmitter power way:1 pcs CR1616buttom battery
Transmitter's stand by current:-5UA
Transmitter's working current:-15MA
Receiver's working current :-450MA Max volume, min volume-220MA
Receiver stand by current:-10MA
Receiver battery spec.:2 pcs AAA dry battery
Work temperature:0°C-50°C