Specifications
thermal conductivity silicon sealant1.white thixotropic elastomer
2.one-part,room cure
3.good in cold and hot tolerance
80g
Kafuter-5203 Heat Sink Thermal Conductivity Silicon Sealant
(Seal in LED lights, CPU, Radiator)
FEATURES
K-5203 is a reinforced thermally conductive silicone elastomer with great adhesion, insulation and dissipation.
(1) one part, room cure, white thixotropic elastomer.
(2) Excellent in cold and high alternating resistance (-60°c~ 280°c).
(3) No peeling and good disassemble after long time usage.
(4)The elastomer with high bonding strength , the shear strength is 30kg/cm3
APPLICATION
fill, bond, and seal in electronics
1. the gap between CPU and radiators
2. the gap between thyristor control modules and radiator
3. the filling of high-power electronics modules and radiators,etc.
TYPICAL PROPERTIES
Cured | Property Name | K-5203 | |
Appearance | white | ||
Viscosity (cp) | thixotropic elastomer | ||
Density(g/cm3) | 2.0~2.5 | ||
Initial Curing Time(25°c, min) | ≤30 | ||
Uncured |
Mechanical Properties | Tensile Strength (Mpa) | ≥2.5 |
Elongation At Break (%) | ≥100 | ||
Shear Strength (Mpa) | ≥1.5 | ||
Hardness(shore A) | 50~65 | ||
Working Temp (°c) | -60~280 | ||
Electrical Properties | Dielectric Strength(kv/mm) | ≥18 | |
Permittivity (@60Hz) | 2.8 | ||
Volume Resistivity (Ω.cm) | 1×1015 | ||
Thermal Conductivity(w/m.k) | 1.2 | ||
HOW TO USE
Preparation
Clean the surfaces by removing the rust, ash, and oil, etc.
Application
Pierce the opening with the tip of the cap. Fix the nozzle, and coat the clean surface evenly with the adhesives, then bond the two surfaces.
Cure Condition
The elastomer get cure with the depth of 2~4mm in 24 hours (at room temperature, 55% moisture). if the bonded parts is too deep (especially the parts not easy to contact with air) or the temperature is too low, the full cure time will be extend.
Advise users prepare enough time to let elastomer get full cure in order to keep the properties stably.
ATTENTION
1. After the application, screw its nozzle tightly and store in dry and cool place for next time using.
2. There may be some cured gel around the opening when you use it again, just remove the cured, and use the uncured.
PACKAGING
45g/ tube
STORAGE
Store in cool and dry place, the shelf life is 12 months (≤25°c)
