Specifications
cheap led rope lights1.2-part, clear liquid
2.potting in 6mm-2cm long tubes
3.good transparency,waterproofing
4.40KG
Kafuter High Quality LED Strip Light K-5502 Silicone Sealant for Cheap LED Rope Lights
Features:
(1) Two-component, good adhesion to metals without any corrosion.
(2) Room cure, or heat cure to fasten the cure speed.
(3) Good transparency, can form a clear silicon elastomer after cured. Especially suitable for optics and LED components potting and encapsulating.
(4) Good yellow, heating and cold tolerant, and UV resistance.
APPLICATION:
(1) Encapsulating the soft strip lights or other flexible neon lights .
(2) Protecting the electronic components.
(3) Protecting the jointing of communication cable and parts
(4) High sealing the optics fittings
(5) Potting and protecting sensor parts.
Good adhesion to flexible PC circuit board, silicone casings, apply in encapsulating and waterproofing of full casing and half-casing in LED tube light. The waterproof level of encapsulated half-casing up to IP65, and the full casing up to IP68.
PROPERTIES
Item | K-5502 (Transparent) | |
Uncured | Appearance | A: transparent liquid B: transparent liquid |
| Viscosity (250C, mpa.s) | A: 3000 B: 3000 |
| Specific Gravity (250C, g/cm3) | A:0.97 B:0.97 |
| Mix Ratio(by weight) | A:B=1:1 |
| Controllable Time (250C,min) | 30 |
| Initial Curing Time (25,0Ch) | 30 |
| Full Curing Time (250C,h) | 24 |
Cured | (Shore A) Hardness(24h) | 15 |
| Volume Resistivity (Ω.cm) | 1.0×1014 |
| Dielectric Strength (MV/m) | 16 |
| Operating Temp (0C) | -60~200 |
Directions:
1. Measurement
Fully mix component A before using, accurately weighing A part, and then put the Part B to mix with Par A by mix ratio. It can adjust by your own needs according to the specification.
2. Mixing
Put Part B in the bottle with Part A, evenly mix them immediately. And should tighten-sealed the Part B after using.
3. Pouring
Put the mixed glue evenly into the product which need encapsulate immediately.
4. Curing
The encapsulated components can be room cured, and it can put into next process after 10 to 24 hours full cure.
