Specifications

Commodity:Steel Sheet Profile
It is used in bridge,construction and drainage systems. we can produce by customers request

Commodity:Steel Sheet Profile

A metal sheet pile has an improved joint strength and is suitable for high productivity manufacturing. Right and left end flanges are formed at opposite sides of the rolled steel sheet pile. Joints are formed at edges of the right and left end flanges. Cross-sections of the joints are point-symmetric or line-symmetric, wherein the end flange and the joint are disposed so that a center of point-symmetry of a pair of interfitted joints is located on or near a centerline of the end flange in the thickness direction. Furthermore, the joint has a protrusion for preventing rotation near the border between the joint and the end flange portion.

• Sheet pile walls are usually used in soft soils and tight spaces. Sheet pile walls are made out of steel, vinyl or wood planks which are driven into the ground. For a quick estimate the material is usually driven 1/3 above ground, 2/3 below ground, but this may be altered depending on the environment. Taller sheet pile walls will need a tie-back anchor, or "dead-man" placed in the soil a distance behind the face of the wall, that is tied to the wall, usually by a cable or a rod. Anchors are placed behind the potential failure plane in the soil.
• It is very important to have proper drainage behind the wall as it is critical to the performance of retaining walls. Drainage materials will reduce or eliminate the hydrostatic pressure and will therefore greatly improve the stability of the material behind the wall, assuming that this is not a retaining wall for water. Sheet piling is a form of driven piling using thin interlocking sheets of steel to obtain a continuous barrier in the ground. The main application of steel sheet piles is in retaining walls and cofferdams erected to enable permanent works to proceed. Normally, vibrating hammer, t-crane and crawle drilling are used to establish sheet piles