2013 new logo light projector brand car logo led laser light
USD $1 - $12 /Set
Min.Order:5 Sets
Shenzhen Chengming Technologies Co., Ltd.
2013 New Logo Light Projector Ghost Shadow door light Car Laser Film for Volvo
2013 new arrival brand car logo laser light (Car Logo Courtesy Door Light) for VW
Car LED boss logo laser door light welcome light LED car door laser projector light for audi
LED car door Laser logo led door ghost shadow projector lights for BWM
LED logo laser light LED car door for Seat
Introduction:
This product works as car courtesy light, when you open the door, the car logo will be projected on the ground. When the door is closed, the light will be off automatically. You will find this light is so cool when you open the door! You also can show it off among your partner or friends, it will be given you more and more respect and applause.
This product applies a new type of green light source. The whole set of lamps makes no noise or pollution & free from electronic interference. By applying German advanced constant-current control technology, the light is characterized by uniform illumination with beautiful richer constant color.
Product's photo for reference:
Specification and Feacture:
1) Working Voltage: 12V~24V constant currency; Power output: 5W
2) Product size: 84mm (length) x 28mm ( diameter)
3) high power super bright LED; working temperature: -40'C~105'C
4) Casing material: High-strength alloy case
5) Waterproof, shock resistance
6) You can change the car logo film yourself
How to install:
This product should be installed at the bottom of the door flame and make sure the Len vertical with the ground
1) Pull down the inside door board first. Mark the suitable location for drilling a hole.
2) Drill the hole on the bottom of the door frame
3) Insert the product from the bottom of car door, then arrange the power cord.
4) Install the nut through the power cord upon the hole inside; tighten the nut;
5) Connect the power cord according to the installation guide;
6) Adjust the lamp projection to the suitable place with wrench tool.
7) Reinstall the inside door board, then check the final effect.
Photoes to show how to install car logo laser light: