64pcs 5050 RGB led MTB wheel light
<A.> SPECIFICATION:
1. 64pcs 5050 RGB led form two light bar.
2. Two ends of light bar fixed on spoke firmly, easy installation and quick release .
3. Cycling speed needed only over 15km/h.
4. User can program personally or input 21 kinds of colorful pictures or words into the chip of light at most with software, format can be JPG, PNG, BMP .
5. Software can be worked under WINDOWS7/ XP/ PC system.
6. Prism reflection technology (patented) that makes 64 led display performance as 128 led, pictures can be displayed on both side of cycle, high resolution, save energy.
7. Work with rechargeable Lithium - ion 900mAH battery, can be worked continuously above 8 hours, just pull off the battery with USB plug from light charging by PC or Power Bank .
8. Manual and intelligent induction button control light to work on or off automatically so to save battery power when wheels stop.
<B.> INSTALLATION
1. Fix battery box to the hub by nylon cable tie (figure 1)
2. Pull tight the tie and cut off the extra part.(figure 2)
2. Put the light bar upper the hub, making the center grooves of the light bar corresponding the convex grooves of the hub, fixing the two plastic clamps on light bar .(figure 3)
3. Adjust the two clamps according to the spoke direction .
4. Fix the magnet sensor on fork tightly, please note the direction of it must be face to the black sensor on the light bar end, the distance of two sensors should be no more than 10mm, otherwise the light cannot work properly.
<C.> OPERATION
1. Connect the battery box and the light bar by their two interface plug , all 64pcs led will flash if connection is right.
2. The light bar will flash red when the black sensor turns round near to magnet sensor on fork , it means two sensors installed correctly.
3. Quick pressing the button on center of the light bar, all led flash then light can work properly.
4. Long pressing the button over three seconds ,light flash green means light getting into rear wheel working mode while flash blue means light work under front wheel working mode.
<D.> Package
1 set in to individual colored blister box, 20pcs per Carton.
Carton size 48*32*29cm, G.W.: 7.2KG/Carton
<E.> OTHER ACCESSORIES
1. Nylon cable tie 4pcs
2. Light clamp 2pcs.
3. Plastic screws 2pairs
4. USB data wire 1pcs.
Real product showing:
