Specifications

Closed Circuit Water Cooling System
1. Max. Tem. Resistance is 95 deg.
2. Good cooling effect
3. Energy saving

Closed Circuit Water Cooling System 

 

Technical Parameter:

 

Content	Technical Parameter
Design Condition
Cooling capacity (MW)	100000Kcal/h
Inlet/Outlet Temperature	<55°C
Flow of Circuiting water	10-30T/H
Quality of spraying water	Clean water/urban waterways
Tower Body
Length (mm)	3000
Width  (mm)	1000
Height  (mm)	1950
N.W./Operation Weight(kg)	840/1860
Pipe Size
Inlet size	DN65
Outlet Size	DN65
Overflow Pipe	DN15
Drain Pipe	DN15
Filling water pipe	DN15
Cooling Fan
Air capacity m3/h	24000
Diameter /Number of fan	1200mm x 2
Power (kw)	1.5
Motors	TEFC
Power Supply	380V/3P/50HZ
Insulation Grade	F

 

 

Configuration and introduction of Closed Cooling Tower  

 

1. Cooling Principle

 

Main host of cooling tower consists of shell, heat exchange, fan blower, spray pump, water eliminator, water basin and pipe valves etc. The process fluid is circulated through the coil of the closed circuit cooler. Heat from the process fluid is dissipated through the coil tubes to the water cascading downward over the tubes. At the same time, air is drawn in through the air inlet louvers at the base of cooler and travels upward over the coil opposite the water flow. A small portion of water is evaporated which removes the heat. The warm moist air is discharged to the atmosphere. The remaining water falls to the sump at the bottom of the cooler where it is recirculated by the pump up through the water distribution system and back down over the coils.

 

2.Structure Principle Drawing: