Product Details

Product Description

Certification:CE/ROHS

LED CEILING LAMP WITH MICROWAVE SENSOR

Welcome to use ES-ML03B Microwave LED Sensor Light!

The product adopts microwave LED sensor mould with high-frequency electro-magnetic wave (5.8GHz), integrated circuit, SMD LED. It gathers automatism, convenience, safety, saving-energy and practicality functions. The wide detection field is consisting of detectors. It works by receiving human motion. When one enters the detection field, it can start the load at once and identify automatically day and night. Its installation is very convenient and its using is very wide. Detection is possible through doors, panes of glass or thin walls.

SPECIFICATION

MODEL	ES-ML03B
Material	PC Cover
DETECTION RANGE	3,5,8,10m
DETECTION ANGLE	360°
POWER SOURCE	110V-130V/AC 220-240V/AC
RATED LOAD	LED 16W
TIME SETTING	10Sec ,1,5,10Min.(adjustable)
Tranamission Power	0.3mW
Ambient light	10,30,50, Lux (adjustable)
HF System	5.8GHz CW radar,ISM band
Power Consumption	<0.9W
Production Size	D 300mmxH100mm

FUNCTION:

Ø Can identify day and night: It can work in the daytime and at night when it is adjusted to the “sun” position (max). It can work in the ambient light less than 10LUX when it is adjusted to the “moon” position (min). As for the adjustment pattern, please refer to the testing pattern.
Ø SENS adjustable: It can be adjusted according to using location; low sensitivity with 3m for detection distance; High sensitivity with 16m, it fits for large room.
Ø Time-Delay is added continually: When it receives the second induction signals after the first induction, it will compute time once more on the basic of the first time-delay rest.
Ø Time–Delay is adjustable. It can be set according to the consumer’s desire. The delay Time :10s ,1 , 5, 10 min.

NOTE:

the highfrequency output of the HF sensor is <10Mw- that is just one 100th of the transmission power of a mobile phone or the output of a microwave oven, the baby can't touch it

INSTALLATION: (see the diagram)

Ø Switch off the power.
Ø Taking down the plastic shade by turning it as the “OPEN’ direction.
Ø Put the wire through the rubber band which is at the bottom pan of light, and connect the wire with terminal according to connect-wire figure.
Ø Fix the base on the ceiling through the holes on the bottom pan with enclosed inflated screws
Ø Switch on the power and test it.

CONNECTION-WIER SKETCH DIAGRAM

Connecting the power source into the ”N” , ”L” according to connection wire diagram when you install it.