Specifications

Extend HDAV and Ethernet to100m Over One Cat5e/6 Cable

The Extender is based on the HDBaseT technology. It extends your HD display with the resolutions of 1080p/60Hz up to 330 feet (100 meters) away from your HDMI or DVI-D source using one CAT5e/6 cable. It also extends Ethernet and provides an IR back channel to control AV sources using the same CAT5e/6 cable. The three Ethernet ports on both the Sender and Receiver are connected to standard network devices such as 100Base-T routers and hubs. Built-in IR extender function allows IR remote control of Source devices from remote viewing location by sending IR commands received in the vicinity of the Display back to the Source devices.

Features:
1,Supports HDCP
2,Supports uncompressed HDMI signal.
3,Enables HDMI10.2 Gbps and 100Mbps Ethernet in parallel over a single 100m Cat5e/6 cable.
4,Supports 340MHz/3.4Gbps per channel (10.2Gbps all channel) bandwidth.
5,Supports 1080p@60Hz@48bit pixels
6,Supports 3D pass-through.
7,Supports CEC pass-through.
8,Supports uncompressed audio such as LPCM.
9,Supports compressed audio such as DTS Digital, Dolby Digital(including DTS-HD and Dolby True HD).
10,There are 3 standard Ethernet ports with switching capabilities on each unit. There is no difference 12,between the 3 and any type of connection topology is permitted.
11,Built-in IR extender function allows IR remote control of Source devices from remote viewing location by sending IR commands received in the vicinity of the Display back to the Source devices.
12,CAT5e/6 cable follows the standard of IEEE-568B.