plug in thermostat

FEATURES:

1.Press PWR and UP button simultaneously for about 3 seconds to switch between heating and cooling.

2.Press UP and DOWN button simultaneously for about 3 seconds to switch between ℃ and ℉.

3.  Default statues:

Default SET Temperature: 20℃.

Default Mode: Heating

4.  Setting:

4.1 Press the Power button (2c) to set the value of temperature.

4.2 Cooling(Snowflake):

A. Press “UP” or “DOWN” repeatedly, set “SET” temperature at least 2℃ lower than “RM” temperature. After 1-3 minutes, LED will turn green, outlet will turn on.

B.When“RM” temperature reaches “SET” temperature, LED will turn red and snowflake will disappear, outlet will turn off.

C. When “SET” temperature is higher than “RM” temperature, LED will display red and outlet will turn off.

    4.3 Heating (Flame):

A. Press “UP” or “DOWN” repeatedly; set “SET” temperature at least 2℃ higher than “RM” temperature. After 1-3 minutes, LED will display green, outlet will turn on.

B. When “RM” temperature reaches “SET” temperature, LED will turn red and flame will disappear, outlet will turn off.

C. When “SET” default temperature is lower than “RM” temperature, LED will display red and outlet will turn off.

General Specification

1. Operating voltage: 230V AC/ 50Hz;

2. Load (Max):

16A  3680W  –  Resistive load;

3. Operating Temperature:  -10°C ~ 70°C.

4. Temperature Control range:  5°C (40°F) ~ 30°C (85°F);

  Precision: ±1°C;

  Measuring period: 10 S.

IMPORTANT SAFETY PRECAUTIONS

Do not use an extension lead.

Do not plug any device performing mechanical movement directly into the temperature controller.

Fan or other appliances with exposed elements should not be left unattended, and it is recommended that these types of appliances are not connected to the temperature controller.

Do not insert needles or any other metal objects into mains outlet.

Avoid moisture, extreme temperatures, shock and vibration.

Used indoors only and do not be exposed in sunshine.

Recommended ambient temperature is 10ºC to 40ºC

Do not open the temperature controller. Repaired must be performed by authorized service personnel only.

To clean casing and display use a soft cloth. Do not use chemical or scouring agents. Do not submerge in water.

Keep device out of the reach of children.

Back up Battery:

Unit provide a Li back up battery CR2032.

When the LCD displays “LO”. Replace the battery at

the battery compartment at the back of the unit.

Remark:

When the unit is unpack from the packaging. Take off the LCD cover label and the tag which protect the contact for the battery from the battery compartment.

 each pieces one carton