Specifications

1.Advertising PVC/poster/ banner welding machine
2.Adjust speed and temperature
3.digital display and automatic
4.CE

Advertising PVC/poster/ banner welding  machine

(ChunLei Machine)

Application

Welding and joining separate pieces made of some hot melting materials, such as PVC fabric, PE canvas, outdoor poster banner, textilene, plastic pieces, and so on. It is also used to laminate and hem the margin in edge-works of the pieces

Technical data

Voltage	110V/220V
Frequency	50/60HZ
Power	1200W-1600W
Air pressure	2500Pa
Temperature	0-600 degree centigrade
Welding Speed	0-10m/min
Gross weight	18Kg
Welding width	10-50mm
Welding thickness	0.5-3mm
Packing size	490mm*290mm*280mm

Operation steps

1.Make the picture smooth and tight,take jointer to accurate (about 2-4cm), fixed edges with tape or glue on the ground

2. Open the power, turning handle to left to keep hot air nozzle and the rubber tire is on the straight line.Then turn the right black knob to adjust the speed, generally marked on the knob points to the location between 2 from 4.After setup, turning the handle to right until the hot air out of the ground

3. Set the temperature degree.And turn the golden knob until it clicks and then follow the button to the end. Set the desired temperature according to thickness of picture . Generally, the temperature is between 300-350°C

4. In the welding process,if printing material is burnt, the first thing to slow down the speed or low the temperature,This can avoid to  burnt picture material,but do not increase speed rapidly, otherwise the machine will  run too fast to make it go straightly,this will cause the picture can not be spliced and damage the picture.

5. Before using ,please find the proper temperature and speed according to your printing material. Therefore, it is very important that the temperature and speed are good match

6. After welding ,turning the handle to right to keep hot air gun from picture competly,then turn off the temperature switch.No luging the power cord and turning the power off directly ,to avoid heat damage to the hot air gun

7. Don’t use it in rainy day,the workplace should be dry, flat and safety of fire.The machine should have technical person to oprate, it is forbid that someone use it without specific knowleage

Notice

1. You should ajust the temperature and speed according to the thickness of your materials

2. Fix the cloth on the smooth ground to make sure the best result

3.Clean the nozzle with copper brush

4.Clean the air inlet with soft bristle brush

5.Check the power cord and plugs to avoid any mechanical damage

Also we send machine to customer ,we will provide extra heater part to customer

Our company produce many different model welding machine , such as model 4000L , model 3000LC , model 4000C , model 2000C and other high quality model . If you have any other questions about our machine ,please contact us .

And our company have other machine , such as automatic eyelet machine , hand eyelet machine , hot laminator , cold laminator machine , if you interesting our machine , please tell us , we will send details information to you .