gsm 850 1900 dual band repeater cellular repeater
USD $1 - $1,999 /Set
Min.Order:1 Set
Quanzhou Kingtone Optics & Electronics Technology Co., Ltd.
gsm 850 1900 dual band repeater cellular repeater is designed to solve problems of weak mobile signal, which is much cheaper than adding a new Base Station (BTS). Main operation of RF Repeaters system is to receive low power signal from BTS via radio frequency transmission and then transmit the amplified signal to the areas where network coverage is inadequate. And the mobile signal is also amplified and transmitted to the BTS via the opposite direction.
Applications
To expand signal coverage of fill signal blind area where signal is weak
or unavailable. Outdoor: Airports, Tourism Regions, Golf Courses, Tunnels, Factories, Mining Districts, Villages etc.
Indoor: Hotels, Exhibition Centers, Basements, Shopping Malls, Offices, Packing Lots etc.
It is mainly applicable to such case:
The repeater can find an installation place which can receive pure BTS signal at strong enough level as the Rx Level in repeater site should be more than -70dBm; And can meet the requirement of antenna isolation to avoid self-oscillation.
Technical Specifications
Items | Testing Condition | Specification | ||
Uplink | Downlink | |||
Working Frequency(MHz) | Nominal Frequency | 824 – 849MHz | 869 - 894MHz | |
1850 – 1910MHz | 1930 - 1990MHz | |||
Gain(dB) | Nominal Output Power-5dB | 95±3 | ||
Output Power (dBm) | GSM modulating signal | 37 | 43 | |
ALC (dBm) | Input Signal add 20dB | Po≤±1 | ||
Noise Figure (dB) | Working in-band(Max. Gain) | ≤5 | ||
Ripple in-band (dB) | Nominal Output Power -5dB | ≤3 | ||
Frequency Tolerance (ppm) | Nominal Output Power | ≤0.05 | ||
Time Delay (us) | Working in-band | ≤5 | ||
Peak Phase Error(°) | Working in-band | ≤20 | ||
RMS Phase Error (°) | Working in-band | ≤5 | ||
Gain Adjustment Step (dB) | Nominal Output Power -5dB | 1dB | ||
Gain Adjustment Range(dB) | Nominal Output Power -5dB | ≥30 | ||
Gain Adjustable Linear(dB) | 10dB | Nominal Output Power -5dB | ±1.0 | |
20dB | Nominal Output Power -5dB | ±1.0 | ||
30dB | Nominal Output Power -5dB | ±1.5 | ||
Inter-modulation Attenuation (dBc) | Working in-band | ≤-45 | ||
Spurious Emission(dBm) | 9kHz-1GHz | BW:30KHz | ≤-36 | ≤-36 |
1GHz-12.75GHz | BW:30KHz | ≤-30 | ≤-30 | |
VSWR | BS/MS Port | 1.5 | ||
I/O Port | N-Female | |||
Impedance | 50ohm | |||
Operating Temperature | -25°C ~+55°C | |||
Relative Humidity | Max. 95% | |||
MTBF | Min. 100000 hours | |||
Power Supply | DC-48V/AC220V(50Hz)/AC110V(60Hz)( ±15%) | |||
Remote Monitoring Function | Real-time alarm for Door Status, Temperature, Power Supply, VSWR, Output Power | |||
Remote Control Module | RS232 or RJ45 + Wireless Modem + Chargeable Li-ion Battery |
Frequency range list for our repeaters :
Support System | Frequency Range | Output Power |
GSM900MHZ | 890-915MHz/935-960MHz | 2W/5W/10W/20W/30W/40W/50W/60W |
DCS1800MHz | 1710-1785MHz/1805-1880MHz | 2W/5W/10W/20W/30W/40W/50W/60W |
PCS1900MHz | 1895-1910MHz/1975-1990MHz | 2W/5W/10W/20W/30W/40W/50W/60W |
GSM850MHz | 824-849MHz/869-894MHz | 2W/5W/10W/20W/30W/40W/50W/60W |
CDMA450MHz | 450-457.5MHz/460-467.5MHz | 2W/5W/10W/20W/30W/40W/50W/60W |
CDMA800MHz | 824-849MHz/869-894MHz | 2W/5W/10W/20W/30W/40W/50W/60W |
CDMA1900MHz | 1880-1890MHz/1960-1970MHz | 2W/5W/10W/20W/30W/40W/50W/60W |
UMTS850MHz | 824-849MHz/869-894MHz | 2W/5W/10W/20W/30W/40W/50W/60W |
UMTS2100MHz | 1920-1980MHz/2110-2170MHz | 2W/5W/10W/20W/30W/40W/50W/60W |
GSM900/1800MHZ | 890-915MHz/935-960MHz 1710-1785MHz/1805-1880MHz | 2W/5W/10W/20W/ |
GSM850/1900MHZ | 824-849MHz/869-894MHz 1880-1890MHz/1960-1970MHz | 2W/5W/10W/20W |
GSM900/UMTS2100 | 890-915MHz/935-960MHz 1920-1980MHz/2110-2170MHz | 2W/5W/10W/20W/ |
Our repeater support above frequency range .
Our present manufacturing service:
1. Single-band repeaters of LTE/GSM/CDMA/PCS/DCS/WCDMA
2. Dual-band repeater of GSM/DCS; GSM/WCDMA; CDMA/PCS;
3. Tri-band repeater of GSM/DCS/WCDMA
4,Trunk Amplifier
5. All kind of Antenna/Splitter/Connector/Cable
Question: I work in an office building where my cell phone coverage in certain areas, including my office, is non-existent or spotty at best. How can I improve my coverage?
Answer: The requirement for reliable, always-on cell phone coverage within the office environment is increasing dramatically. It is not unusual to encounter trouble spots within a building where cell phone signals are weak or non-existent.
Kingtone repeater provides affordable and clear coverage to those trouble spots. The unit can be easily deployed and provides a coverage range of up to 100,000 square feet. Multiple units can be easily deployed to cover office areas and working locations.
Kingtone repeater can be deployed even without access to the roof or outside.
welcome you to visit our company website: , for more information .
Quanzhou Kingtone Optics & Electronics Technology Co., Ltd Add:3th Floor,Bld B,Yucheng Base, Keji Road,Fengze district ,Quanzhou ,Fujian,China. |
Email: cary @ Tell: 86 595 28857991 Whatsapp:+86 13506927982 skype: cary.cao4 Web: ; |