1. Technical parameter 

Note: This set of equipment only by the arc gun, arc spraying of power supply. Air compressor/ air cleaner/ put silk plate frame is option.
 
- The one-piece electric control pneumatic, electric switch, the operation more
convenient, may realize the long distance race homework.
- The speed of 420 particles m/s above.
- Axial flow speed of 600m/s.
- Coating deposition rate of more than 75%.
 

2. Main introduction

- Thermal spraying series process: add some heat source and to heat up the spraying materials (wire or powder materials), heated material form melting or half melt condition of particles, these particles are power by compressed, to certain speed for the impact and deposition in the matrix surface, form a spray coating with some characteristics.

- To the different provide between heat source it can be divided into burning method and heating method. The former includes combustion flame spraying, explosion spraying and the flame spraying (HVOF). The latter include arc spraying and plasma spraying (is divided into atmospheric plasma spraying and plasma spraying water stability). Spraying process have an important impact on the coating is that spraying temperature (Strict said, it is the temperature of dissolve drops the matrix surface of the impact) and dissolve the speed of the impact drops surface.

- Hot spraying system, which is used for light pole, bridges, tower, the locks, shipbuilding and other structural long-term anti-corrosion and paper dryer, printing roll, crankshaft etc of work-piece surface wear spraying repair, also applies to capacitor, electroceramics electrode coating industry.