Polyethylene pipe for water supply(HDPE pipe)

PE water supply pipe takes special purpose polyethylene as raw material and be extruded by once-shaping technology from a plastic extruder. the pipe can be used for urban water supply pipe networks, irrigation and water diversion project and agricultural spray irrigation project, especially for anti-corrosion and acid-resisting environment .because PE pipes adopt hot-melt connection and electrical hot-melt the joint and pipes, thus it can be resistant to hook stress resulted from internal pressure and impact resistance resulted from the axial direction.Additional,PE water pipes doesn’t contain heavy metal salt stabilizer, thus secondary pollution for drinking water is avoided for the pipe material non-toxic, no scaling ,and no bacteria breeding.

Standard

Our product “PE water supply pipe “is produced and tested as per the requirements of international standard GB/T13663-2000.

The do’s and don’ts

Hot-melt connection should be operated stringently in accordance with the specified deepness.

Hot-melt connection should be operated stringently in accordance with the specified time.

During hot-melt connection, pipes and pipe fittings shall not exceed the maximum deviation angle of 5 degrees.

The minimum bending radius may not be less than 8 times of pipes’ diameter when pipes is bended. Prohibit heating an bending pipes with naked flame.

We adopt the design of V-shaped thread in the design of metal thread, and it could be sealed by hemp or Teflon tapes in connection.

When two pipes overlaps, bent pipes must be used.

PE water supply pipe should be avoided as the use of climbing and lifting frame.

After pipe being buried, the position and direction should be marked.

Prohibit knocking pipes with sharp objects like metal nail etc.