Introduction

This product is a wide angle passive infrared detector, exquisite design, easy installation, can be ceiling or wall mounting. Fit for the locations of the balcony, window, door, corridors etc. Imported high-end infrared sensor, SMT chip technology, anti-EMI & anti-RFI design, temperature compensation, pulse count (optional), LED switch etc. selectable functions, can be integrated with wired alarm host in domestic and abroad.

Function Features

1.      MCU Technology to prevent all kinds of false alarms

2.      Anti-RFI & anti-EMI

3.      Automatic temperature compensation technology, Adjustable pulse count

4.      Anti-tamper alarm function to enhance anti-damage

5.      LED ON/OFF optional, better concealment

6.      The power connector with polarity protection function

7.      Walling amounting.

8.      Alarm output: NC/NO optional

Product Schematic

1.      Wiring Terminal

2.      Wire holder

3.      Anti-tamper switch

4.      PIR sensor

5.      Temperature sensor

6.      Relay

7.      Pulse adjustment

8.      LED indicator light

9.      LED indicator light Switch

10.Pulse Modulation

Technical parameter:

Working voltage: DC 9V-12V

Working current: ≤18mA

Operating temperature:-10°C ~+50°C

Sensor:Dual- element pyroelectric infrared sensor

Detection distance: 12m (25℃)

Alarm output:NO/NC(500mA 100VDC)

Tamper output:NC(50mA 30VDC)

LED indicator light:ON/OFF optional

Size: 134mm*60mm*45mm

Installation method

A. Wiring Terminal

1.      open the front cover of detector and take out the PCB

2.      open the back cover of detector and put the wire into the hole

3.      connect the terminal blocks (wiring diagram A)

4.      cover the detection front cover

5.      select the appropriate height of installation (recommend 2.2m )

B. Wire holder

1. Introduce the wire to the bracket of the sensor and connect the terminals.

   (See Wiring diagram B)

2. Install the bracket at the right location (recommend 2.2m )

3. Take out the detector and install it into the bracket accordingly, adjust the angle.

Product Schematic

Installation Notice:

Please refer the content as follow before installation

1.      Should install in the place which is most likely to illegal invasion.

2.      Avoid the detector in the cold, heat exit.

3.      Avoid the installing in sunlight or strong electromagnetic interference

4.      Avoid larger air flow in detection area.

5.      Avoid blind spots in protected areas,

Product use

1.      Plug in 12V DC power, and red indicative light is on, detector enters the self-checking states. After 60 seconds, indicative light is off, and the detector enter monitoring state

2.      Sensitivity adjusting(P.COUNT): 1&2 is high sensitivity for the normal environment, 2&3 is low sensitivity for the interference environment

3.      Selection of output relay(RELAY): 1&2 is NC ,2&3 is NO

4.      Selection of LED switch (LED ON) : insert Mini Jumper, the light is turned on, without Mini Jumper, light is off

Notes:

1.      Please install according to the manual and don’t touch the surface of sensor to avoid influencing on the sensitivity. Please break the power and use a soft cloth with a little alcohol to clear.

2.      The PIR detector distance will be influenced by the temperature, please should be avoided in places with large temperature differences

3.      Anti-theft products can increase the safety factor, but not guarantee to be absolutely safe. For your safety, in addition to the proper use of this product, you also should be vigilant in daily life, strengthen the awareness of security.