Specifications

2500w large power poster welding machine for flex  banner

large power poster welding machine for flex  banner

1) Alternant electric voltage: 220V/50Hz;
2) Upper limit power: 2000W, average 800W;
3) Adjustable work temperature: 50-600°C;
4) Adjustable: self-move speed 0.8-15M/per minute;

5)Specification:   450*310*320mm

6) Whole weight:  10 kilogram;

7) Splicing width: 2-5cm.

Banner  welding machine specification:

1.The wind power can adjust, if you weld thick flex, choose high wind power; if you weld thin flex, then choose low wind power

2.It can turn off automatic when no people operate. If no work in 15minutes, it will turn off the   heater at first, and after more 3 minutes, it will turn off the power automatic.

3.automatic control by itself

4.The price of this machine is economical and practical.

5. Movable, low volume

6. Not  affected by the low temperature.

Application:

 banner welding machine can laminate and bond up disjunct flat painting surface made of heat-melted

material, such as outdoor advertising poster, PVC cloth & PE fabric Canvas, outdoor

poster banner, plastic surface, Sailcloth etc.

When use:

1) Immobilise both ends of each disjunct poster surface with something

such as stick belt or clamp, and leave about 30-40mm wide overlap edge on each

disjunct poster surface edge;

2) Turn on the machine, prepare warm up about 2 minutes;

3) Bring up the machine, and place the roll at the end of the overlap edge;

4) According to quality and thickness of the poster surface material, consider the

ground circumstance, adjust the proper temperature and speed, handle the Fuse

machine Gun down and insert it between the two poster banner edges, then the

machine start running, after go pass the overlap edge, the two disjunct banners

will be well joined in one.